Assembly categories
Filters Brake System Axle Steering Cooling / AC Electrics Towbar/Accessories Transmission Exhaust System Body Ignition Engine Windscreen Cleaning Lights Fuel Supply Interior ServiceProduct
Description
In stock
Price
(incl. VAT)
- Fitting Position: Pipe at EGR valve
- Number of mounting bores: 4
- Manufacturer: ELRING
- for OE number: 651 142 0480
- Manufacturer: TRUCKTEC
- Fitting Position: Bypass Flap at EGR cooler
- Manufacturer: ELRING
- Gasket Design: Steel
- Number of flange connections: 2
- Number of mounting bores: 7
- Manufacturer: TOPRAN
General Information: Any and all spare parts we supply are solely intended for the designated purpose as defined by us. Installation by trained personnel only. Our products are usually supplied without assembly instructions. Installation in vehicles other than those specified by us may lead to the exclusion of warranty.
- Fitting Position: Bypass Flap
- Manufacturer: FISCHER
- Fitting Position: Pipe at EGR valve
- Manufacturer: ELRING
- Number of mounting bores: 2
- Number of bores: 2
- Manufacturer: ELRING
- Number of mounting bores: 2
- Fitting Position: Exhaust Manifold
- Manufacturer: ELRING
- Material: Metal
- Fitting Position: Pipe at EGR valve
- Name: DRM 0459
- Manufacturer: DR.MOTOR AUTOMOTIVE
- Number of mounting bores: 2
- Name: FI EG1400916
- Manufacturer: FA1
- Material: Rubber
- Manufacturer: DR MOTOR
- Thickness [mm]: 0.6
- Width [mm]: 40
- Length [mm]: 68
- Fitting Position: Exhaust Manifold
- Manufacturer: AJUSA
-
for article number: V30-
63- 0042 - Fitting Position: Engine Compartment
- Number of Gaskets/Seals/Seal Rings: 4
- Manufacturer: VEMO GERMANY
General Information: In the warranty, we always make a distinction between wear parts and vehicle parts. All wear parts are subject to a reduced warranty period and a maximum mileage. Brake components such as brake disks, brake pads, etc. maximum of 1000 km (break-in period). Therefore, warranty claims for brake parts are only reviewed with an installation invoice and a record of the wheel hub run-out measurement, including photos. For brake disks and brake pads, the break-in requirements specified by the vehicle manufacturer must be observed. When replacing brakes, the chassis components must always be checked with regard to clearance and the wheel hub with regard to wobble, and the appropriate documentation must be produced. If the vehicle is no longer in its original condition due to tuning work such as wheel accessories and tracking plates, the entitlement to make warranty claims is lost due to third-party work. The same warranty claims are lost if the vehicle is used for motor sports or similar events.
Laki Auto universal products
TecDoc catalogue for cars
TecDoc catalogue for trucks