• Construction Year to: 02.2000
• for OE number: MD339640, MD348460
• Quality: OE
• Manufacturer Restriction: DENSO
• Connector type: with rubber grommet
• Thread Size: M18x1.5
• Cable Length [mm]: 830
• Number of pins: 4
• Weight [g]: 134
• Gross Weight [g]: 167
• Manufacturer: DENSO

Oxygen Sensor: Diagnostic Probe, Heated, Finger probe, Thread pre-greased, Oxygen Sensor Additional information: "Tootja: DENSO
SPACE WAGON (N5/W),
(kvaliteediklass: Q)" Lisainfo: "Tootja: DENSO
SPACE WAGON (N5/W),
(kvaliteediklass: Q)"

• Construction Year to: 02.2000
• Exhaust System: for pre-catalytic converter
• for OE number: MD189008
• Quality: OE
• Manufacturer Restriction: DENSO
• Thread Size: M18x1.5
• Cable Length [mm]: 400
• Number of pins: 4
• Weight [g]: 108
• Gross Weight [g]: 136
• Manufacturer: DENSO
• Name: DN DOX-1438

Oxygen Sensor: Regulating Probe, Heated, Finger probe, Thread pre-greased, Oxygen Sensor Additional information: "Tootja: DENSO
GALANT V SEDAN (E5/A
(kvaliteediklass: Q)" Lisainfo: "Tootja: DENSO
GALANT V SEDAN (E5/A
(kvaliteediklass: Q)"

• Construction Year from: 03.2000
• Fabrication Number: ESL-MS-003
• Manufacturer: NTY

Fitting Position: Front, before catalytic converter, after catalytic converter Oxygen Sensor: Regulating Probe, Diagnostic Probe, Thread pre-greased

• Construction Year to: 02.2000
• Oxygen Sensor: Diagnostic Probe, Thread pre-greased
• Fabrication Number: ESL-SK-000
• Manufacturer: NTY
• Name: NTY ESL-SK-000

• Construction Year to: 02.2000
• Fabrication Number: ESL-MS-009
• Manufacturer: NTY

Fitting Position: Front, before catalytic converter, after catalytic converter Oxygen Sensor: Diagnostic Probe, Regulating Probe, Thread pre-greased

• Construction Year from: 03.2000
• Fitting Position: Front, before catalytic converter
• Oxygen Sensor: Regulating Probe, Thread pre-greased
• Fabrication Number: ESL-MS-000
• Manufacturer: NTY

• Oxygen Sensor: Oxygen Sensor, Thread pre-greased
• Fabrication Number: ESL-UV-001
• Manufacturer: NTY
• Name: NTY ESL-UV-001

• Number of circuits: 4
• Oxygen Sensor: Regulating Probe
• Manufacturer: KAMOKA

• Oxygen Sensor: Diagnostic Probe
• Cable Length [mm]: 900
• Manufacturer: NTY

• Oxygen Sensor: Oxygen Sensor
• Guarantee: 3 years guarantee
• Weight [kg]: 0.12
• Always compare old and new part (in particular OE No.):
• Manufacturer: SKV GERMANY
• Name: CE 09SKV121

• Construction Year from: 03.2000
• Oxygen Sensor: Oxygen Sensor
• Voltage [V]: 12
• Guarantee: 3 years guarantee
• Number of circuits: 4
• Weight [kg]: 0.09
• Resistor [Ohm]: 13
• Operating Mode: Electric
• Always compare old and new part (in particular OE No.):
• Name: CE 09SKV913
• Manufacturer: ESEN SKV

• Construction Year from: 10.1996, 03.2000
• Oxygen Sensor: Diagnostic Probe, Regulating Probe
• Block Separation:
• Number of circuits: 4
• Recommended change interval [km]: 160,000
• Connector/Clamp: Connector may need adjustment
• Manufacturer: ENERGY

Fitting Position: after catalytic converter, for cylinder 1-3, before catalytic converter

• Construction Year from: 03.2000
• Oxygen Sensor: Diagnostic Probe, Finger probe, Heated
• Fitting Position: after catalytic converter
• Cable Length [mm]: 340
• Manufacturer: DELPHI
• Name: DE ES11119-12B1

• Engine Code: 6A13
• Construction Year from: 03.2000
• Fitting Position: Front
• Length [mm]: 500
• Line insulation design: with silicone-coated woven-fibre insulation
• Weight [kg]: 0.1
• Oxygen Sensor: Thread pre-greased
• Manufacturer: VEMO GERMANY

General Information: In the warranty, we always make a distinction between wear parts and vehicle parts. All wear parts are subject to a reduced warranty period and a maximum mileage. Brake components such as brake disks, brake pads, etc. maximum of 1000 km (break-in period). Therefore, warranty claims for brake parts are only reviewed with an installation invoice and a record of the wheel hub run-out measurement, including photos. For brake disks and brake pads, the break-in requirements specified by the vehicle manufacturer must be observed. When replacing brakes, the chassis components must always be checked with regard to clearance and the wheel hub with regard to wobble, and the appropriate documentation must be produced. If the vehicle is no longer in its original condition due to tuning work such as wheel accessories and tracking plates, the entitlement to make warranty claims is lost due to third-party work. The same warranty claims are lost if the vehicle is used for motor sports or similar events.

• Construction Year to: 02.2000
• Exhaust System: for pre-catalytic converter
• Quality: OE
• Thread Size: M18x1.5
• Cable Length [mm]: 750
• Number of pins: 4
• Weight [g]: 103
• Gross Weight [g]: 147
• Name: DN DOX-0109
• Manufacturer: DENSO
• Lisainfo: DOX-0109 DENSO
• Additional information: DOX-0109 DENSO

Oxygen Sensor: Regulating Probe, Heated, Finger probe, Oxygen Sensor

• Construction Year from: 03.2000
• Fitting Position: Rear
• Oxygen Sensor: Heated, Regulating Probe
• External Thread Size: M18 x 1,5
• Spanner Size: 22
• Number of circuits: 4
• Cable Length [mm]: 400
• Weight [kg]: 0.089
• Name: SW 33 10 3158
• Manufacturer: SWAG

General Information: These products are designed to be used as originally intended and not modified for purpose. Please ensure the products are installed by a competent individual. N.B. products are usually supplied without fitting instructions.

• Oxygen Sensor: Oxygen Sensor
• Cable Length [mm]: 290
• Alternatively:
• Supplementary Article/Info 2: without plug
• Number of circuits: 4
• Alternative Repair Kit: 570111
• Manufacturer: ERA

• Construction Year from: 04.1997
• Fitting Position: after catalytic converter
• Block Separation:
• Construction Year to: 02.2000
• Oxygen Sensor: Diagnostic Probe, Planar probe, Heated
• Cable Length [mm]: 580
• Manufacturer: DELPHI
• Name: DE ES20076-12B1

• Construction Year from: 10.1996, 03.2000
• Oxygen Sensor: Diagnostic Probe, Regulating Probe
• Block Separation:
• Number of circuits: 4
• Recommended change interval [km]: 160,000
• Connector/Clamp: Connector may need adjustment
• Manufacturer: BOSCH
• Name: BS 0258986507

Fitting Position: after catalytic converter, for cylinder 1-3, before catalytic converter

• Construction Year from: 03.2000
• Oxygen Sensor: Regulating Probe
• Voltage [V]: 12
• Length [mm]: 470
• Guarantee: 3 years guarantee
• Number of circuits: 4
• Weight [kg]: 0.12
• Resistor [Ohm]: 6
• Operating Mode: Electric
• Always compare old and new part (in particular OE No.):
• Manufacturer: ESEN SKV

• Oxygen Sensor: Oxygen Sensor
• Cable Length [mm]: 290
• Alternatively:
• Number of circuits: 4
• Alternative Repair Kit: 570112
• Manufacturer: ERA

• Engine Code: 6A13
• Construction Year from: 03.2000
• Fitting Position: Left
• Line insulation design: with silicone-coated woven-fibre insulation
• Number of pins: 4
• for OE number: V99760001
• Cable Length [mm]: 210
• Number of circuits: 4
• Weight [kg]: 0.09
• Length [mm]: 350
• Exhaust System: after catalytic converter
• Manufacturer: VEMO GERMANY

Oxygen Sensor: Regulating Probe, Finger probe, Heated, Thread pre-greased Supplementary Article/Supplementary Info: with squeeze connector, with shrink squeeze connector General Information: In the warranty, we always make a distinction between wear parts and vehicle parts. All wear parts are subject to a reduced warranty period and a maximum mileage. Brake components such as brake disks, brake pads, etc. maximum of 1000 km (break-in period). Therefore, warranty claims for brake parts are only reviewed with an installation invoice and a record of the wheel hub run-out measurement, including photos. For brake disks and brake pads, the break-in requirements specified by the vehicle manufacturer must be observed. When replacing brakes, the chassis components must always be checked with regard to clearance and the wheel hub with regard to wobble, and the appropriate documentation must be produced. If the vehicle is no longer in its original condition due to tuning work such as wheel accessories and tracking plates, the entitlement to make warranty claims is lost due to third-party work. The same warranty claims are lost if the vehicle is used for motor sports or similar events.

• Construction Year from: 03.1997
• Quantity: 2
• Fitting Position: after catalytic converter
• Line insulation design: with silicone-coated woven-fibre insulation
• Oxygen Sensor: Planar probe, Heated, Thread pre-greased
• Cable Length [mm]: 210
• Number of circuits: 4
• Weight [kg]: 0.09
• Manufacturer: VEMO GERMANY

Supplementary Article/Supplementary Info: with squeeze connector, with shrink squeeze connector General Information: In the warranty, we always make a distinction between wear parts and vehicle parts. All wear parts are subject to a reduced warranty period and a maximum mileage. Brake components such as brake disks, brake pads, etc. maximum of 1000 km (break-in period). Therefore, warranty claims for brake parts are only reviewed with an installation invoice and a record of the wheel hub run-out measurement, including photos. For brake disks and brake pads, the break-in requirements specified by the vehicle manufacturer must be observed. When replacing brakes, the chassis components must always be checked with regard to clearance and the wheel hub with regard to wobble, and the appropriate documentation must be produced. If the vehicle is no longer in its original condition due to tuning work such as wheel accessories and tracking plates, the entitlement to make warranty claims is lost due to third-party work. The same warranty claims are lost if the vehicle is used for motor sports or similar events.

• Construction Year from: 10.1996
• Construction Year to: 02.2000
• Oxygen Sensor: Regulating Probe
• Block Separation:
• Number of circuits: 4
• Recommended change interval [km]: 160,000
• Connector/Clamp: Connector may need adjustment
• Manufacturer: BOSCH

Fitting Position: before catalytic converter, for cylinder 1-3, for cylinder 4-6

• Construction Year from: 10.1996
• Oxygen Sensor: Diagnostic Probe
• Fitting Position: after catalytic converter, for cylinder 1-3
• Number of circuits: 4
• Overall Length [mm]: 380
• Available as universal article as well, see article no.: 0258986507
• Recommended change interval [km]: 160,000
• Manufacturer: BOSCH

• Construction Year from: 03.2000
• Fitting Position: Front
• Line insulation design: with silicone-coated woven-fibre insulation
• Number of pins: 4
• Connector Shape: angular
• Socket colour: black
• Number of circuits: 4
• Thread Size: M18 x 1,5
• Weight [kg]: 0.131
• for OE number: MD 351752
• Cable Length [mm]: 290
• Length [mm]: 400
• Number of connectors: 4
• Oxygen Sensor: Heated, Thread pre-greased
• Manufacturer: VEMO GERMANY

General Information: In the warranty, we always make a distinction between wear parts and vehicle parts. All wear parts are subject to a reduced warranty period and a maximum mileage. Brake components such as brake disks, brake pads, etc. maximum of 1000 km (break-in period). Therefore, warranty claims for brake parts are only reviewed with an installation invoice and a record of the wheel hub run-out measurement, including photos. For brake disks and brake pads, the break-in requirements specified by the vehicle manufacturer must be observed. When replacing brakes, the chassis components must always be checked with regard to clearance and the wheel hub with regard to wobble, and the appropriate documentation must be produced. If the vehicle is no longer in its original condition due to tuning work such as wheel accessories and tracking plates, the entitlement to make warranty claims is lost due to third-party work. The same warranty claims are lost if the vehicle is used for motor sports or similar events.

• Construction Year from: 03.2000
• Fitting Position: before catalytic converter
• Oxygen Sensor: Heated
• Cable Length [mm]: 410
• Number of pins: 4
• Assy./disassy. by qualified personnel required!:
• Manufacturer: HELLA

Brief Information: *** HELLA Electronics OE competence for over 60 years.

• Construction Year from: 03.2000
• Fitting Position: Front
• Line insulation design: with silicone-coated woven-fibre insulation
• Socket colour: black
• Number of circuits: 4
• Number of pins: 4
• Connector Shape: angular
• Thread Size: M18 x 1,5
• Weight [kg]: 0.115
• for OE number: MD 177969
• Cable Length [mm]: 350
• Length [mm]: 470
• Number of connectors: 4
• Oxygen Sensor: Heated, Thread pre-greased
• Manufacturer: VEMO GERMANY

General Information: In the warranty, we always make a distinction between wear parts and vehicle parts. All wear parts are subject to a reduced warranty period and a maximum mileage. Brake components such as brake disks, brake pads, etc. maximum of 1000 km (break-in period). Therefore, warranty claims for brake parts are only reviewed with an installation invoice and a record of the wheel hub run-out measurement, including photos. For brake disks and brake pads, the break-in requirements specified by the vehicle manufacturer must be observed. When replacing brakes, the chassis components must always be checked with regard to clearance and the wheel hub with regard to wobble, and the appropriate documentation must be produced. If the vehicle is no longer in its original condition due to tuning work such as wheel accessories and tracking plates, the entitlement to make warranty claims is lost due to third-party work. The same warranty claims are lost if the vehicle is used for motor sports or similar events.