• Number of pins: 2
• Lisainfo: Sender Unit, coolant temperature
• Additional information: Sender Unit, coolant temperature

• for OE number: MD189007, MD343421
• Exhaust System: for pre-catalytic converter
• Quality: OE
• Manufacturer Restriction: DENSO
• Thread Size: M18x1.5
• Cable Length [mm]: 780
• Number of pins: 4
• Weight [g]: 134
• Gross Weight [g]: 167
• Manufacturer: DENSO

Lambda Sensor: Regulating Probe, Heated, Finger probe, Lambda Sensor Additional information: "Tootja: DENSO
ECLIPSE II (D3/), 04
(kvaliteediklass: Q)" Lisainfo: "Tootja: DENSO
ECLIPSE II (D3/), 04
(kvaliteediklass: Q)"

• Spanner Size: 13
• for OE number: 8342087703
• Manufacturer: KAMOKA

• Length [mm]: 59
• Housing Colour: black
• Spanner Size: 19
• Manufacturer: KAMOKA

• Fabrication Number: ECC-TY-000
• Spanner Size: 24
• Socket colour: black
• Number of pins: 1
• Manufacturer: NTY

• Engine Code: 6A12
• Pressure [bar]: 0
• Thread Size: 1/8 GAS
• Spanner Size: 24
• Name: OLISURVELšLITUS
• Manufacturer: EPS

• Number of pins: 1
• Plug Type: Blade Terminal
• Colour: black
• Pressure from [bar]: 0.3
• Thread Size: 1/8"x28 BSP
• Spanner Size: 24
• Manufacturer: MEAT&DORIA

• Switch Pressure [bar]: 0.3
• Thread Size: 1/8x28 BSPT
• Sensor Type: Closed-type Sensor
• Name: OLISURVELšLITUS
• Manufacturer: VER

• Spanner Size: 13
• Material: Brass
• Number of pins: 1
• Thread Size: 1/8" - 28
• Name: ANDUR,JAHUTUSVEDELIKU TEMP.
• Manufacturer: MAX

• Thread Size: 1/8x28 BSP
• Pressure [bar]: 0.35
• Manufacturer: FAE

• Fabrication Number: ECT-MS-000
• Name: NTY ECT-MS-000
• Manufacturer: NTY

• Sensor Type: NTC Sensor
• Mounting Type: Bolted
• Number of pins: 1
• Spanner Size: 12
• Thread Size: 1/8
• for OE number: 4671065
• Name: Andur,Jahutusvedeliku temp.
• Manufacturer: NRF

• for OE number: MD 091056
• Number of pins: 1
• Weight [kg]: 0.02
• Manufacturer: VEMO GERMANY

General Information: In the warranty, we always make a distinction between wear parts and vehicle parts. All wear parts are subject to a reduced warranty period and a maximum mileage. Brake components such as brake disks, brake pads, etc. maximum of 1000 km (break-in period). Therefore, warranty claims for brake parts are only reviewed with an installation invoice and a record of the wheel hub run-out measurement, including photos. For brake disks and brake pads, the break-in requirements specified by the vehicle manufacturer must be observed. When replacing brakes, the chassis components must always be checked with regard to clearance and the wheel hub with regard to wobble, and the appropriate documentation must be produced. If the vehicle is no longer in its original condition due to tuning work such as wheel accessories and tracking plates, the entitlement to make warranty claims is lost due to third-party work. The same warranty claims are lost if the vehicle is used for motor sports or similar events.

• Pressure [bar]: 0.3
• Thread Size: 1/8 GAS
• Spanner Size: 27
• Technical Information Number: circuit N.C.
• Manufacturer: ERA

• External Thread Size: 1/8" - 28
• Spanner Size: 13
• Number of connectors: 1
• Material: Brass
• Weight [kg]: 0.01
• Manufacturer: SWAG
• Name: SW 81 92 8265

General Information: These products are designed to be used as originally intended and not modified for purpose. Please ensure the products are installed by a competent individual. N.B. products are usually supplied without fitting instructions.

• External Thread Size: 1/8" - 28
• Spanner Size: 13
• Number of connectors: 1
• Material: Brass
• Weight [kg]: 0.01
• Name: ANDUR,JAHUTUSVEDELIKU TEMP.
• Manufacturer: FEB

General Information: These products are designed to be used as originally intended and not modified for purpose. Please ensure the products are installed by a competent individual. N.B. products are usually supplied without fitting instructions.

• Thread Size: 3/8x19 BSP
• Manufacturer: VERNET

• Spanner Size: 24
• Number of connectors: 1
• Shifting Points [bar]: 0.2
• Weight [kg]: 0.04
• Name: OLISURVELšLITUS
• Manufacturer: BLP

General Information: These products are designed to be used as originally intended and not modified for purpose. Please ensure the products are installed by a competent individual. N.B. products are usually supplied without fitting instructions.

• Thread Size: 1/8 GAS
• Spanner Size: 13
• Number of pins: 1
• Manufacturer: ERA

• Engine Code: 6A12
• Thread Size: 1/8 GAS
• Spanner Size: 13
• Name: ANDUR,JAHUTUSVEDELIKU TEMP.
• Manufacturer: EPS

• Number of pins: 1
• Switch pressure from [bar]: 0.2
• Switch pressure to [bar]: 0.4
• Thread Size: 1/8" BSPT
• Colour: black
• Supplementary Article/Supplementary Info: without gaskets/seals
• Manufacturer: METZGER

• Thread Size: 1/8 x 28 BSP
• Manufacturer: FAE

• Mounting Type: Bolted
• Voltage [V]: 12
• Pressure [bar]: 0.4
• Combi Switch Function: Normally Closed Contact
• Thread Size: 1/8 GAS
• Colour: red
• Spanner Size: 24
• Number of pins: 1
• Assy./disassy. by qualified personnel required!:
• Manufacturer: HELLA
• Name: HE 6ZF007392001

• Engine Code: 6A12
• Construction Year to: 05.1996
• Manufacturer: BOSCH

• Sensor Type: NTC Sensor
• Mounting Type: Bolted
• Connector Shape: rectangular
• Number of pins: 2
• Socket colour: black
• Spanner Size: 19
• Thread Size: 3/8
• for OE number: MD177572
• Name: Andur,Jahutusvedeliku temp.
• Manufacturer: NRF

• Thread Size: 1/8x28 BSPT
• Manufacturer: VERNET

• Thread Size: 3/8 x 19 BSP
• Colour: black
• Spanner Size: 19
• Number of pins: 2
• Weight [kg]: 0.042
• Manufacturer: VEMO GERMANY

General Information: In the warranty, we always make a distinction between wear parts and vehicle parts. All wear parts are subject to a reduced warranty period and a maximum mileage. Brake components such as brake disks, brake pads, etc. maximum of 1000 km (break-in period). Therefore, warranty claims for brake parts are only reviewed with an installation invoice and a record of the wheel hub run-out measurement, including photos. For brake disks and brake pads, the break-in requirements specified by the vehicle manufacturer must be observed. When replacing brakes, the chassis components must always be checked with regard to clearance and the wheel hub with regard to wobble, and the appropriate documentation must be produced. If the vehicle is no longer in its original condition due to tuning work such as wheel accessories and tracking plates, the entitlement to make warranty claims is lost due to third-party work. The same warranty claims are lost if the vehicle is used for motor sports or similar events.

• Mounting Type: Flat Plug-in Connector, Bolted
• Voltage [V]: 12
• Resistor [Ohm]: 628, 70
• Temperature range from [°C]: 25
• Temperature range to [°C]: 80
• Thread Size: 1/8 GAS
• Spanner Size: 13
• Sensor Type: NTC Sensor
• Number of pins: 1
• Housing Colour: black
• Assy./disassy. by qualified personnel required!:
• Name: HE 6PT009107651
• Manufacturer: HELLA

Brief Information: *** HELLA Electronics OE competence for over 60 years.

• for OE number: MD303088
• Cable Length [mm]: 480
• Number of pins: 3
• Connector Shape: triangular
• Socket colour: black
• Fabrication Number: ECP-MS-001
• Manufacturer: NTY

• Number of connectors: 2
• Colour: black
• Weight [kg]: 0.066
• Manufacturer: BLUE PRINT

General Information: These products are designed to be used as originally intended and not modified for purpose. Please ensure the products are installed by a competent individual. N.B. products are usually supplied without fitting instructions.

• Length [mm]: 59.7
• Spanner Size: 19
• Number of connectors: 2
• Colour: black
• Weight [kg]: 0.04
• Manufacturer: FEBI BILSTEIN

General Information: These products are designed to be used as originally intended and not modified for purpose. Please ensure the products are installed by a competent individual. N.B. products are usually supplied without fitting instructions.

• Length [mm]: 59.7
• Spanner Size: 19
• Number of connectors: 2
• Colour: black
• Weight [kg]: 0.04
• Name: SW 80 93 2375
• Manufacturer: SWAG

General Information: These products are designed to be used as originally intended and not modified for purpose. Please ensure the products are installed by a competent individual. N.B. products are usually supplied without fitting instructions.

• Engine Code: 6A12
• Thread Size: 3/8-GAS
• Spanner Size: 19
• Name: ANDUR,JAHUTUSVEDELIKU TEMP.
• Manufacturer: EPS

• Voltage [V]: 12
• Resistor [Ohm]: 2,080, 294
• Temperature range from [°C]: 25
• Temperature range to [°C]: 80
• Thread Size: 3/8 GAS
• Colour: black
• Spanner Size: 19
• Sensor Type: NTC Sensor
• Number of pins: 2
• Corresponds to the original part in colour: black
• Mounting Type: Vertical Screw Fitting
• Assy./disassy. by qualified personnel required!:
• Manufacturer: HELLA

Brief Information: *** HELLA Electronics OE competence for over 60 years.

• Fabrication Number: ESL-MS-009

Fitting Position: Front, before catalytic converter, after catalytic converter Lambda Sensor: Diagnostic Probe, Regulating Probe, Thread pre-greased

• Number of circuits: 4
• Lambda Sensor: Regulating Probe
• Manufacturer: KAMOKA

• Lambda Sensor: Diagnostic Probe, Thread pre-greased
• Fabrication Number: ESL-SK-000
• Manufacturer: NTY
• Name: NTY ESL-SK-000

• Lambda Sensor: Lambda Sensor
• Voltage [V]: 12
• Number of circuits: 4
• Weight [kg]: 0.09
• Resistor [Ohm]: 13
• Operating Mode: Electric
• Warranty: 3 years warranty
• Always compare old and new part (in particular OE No.):
• Name: CE 09SKV913
• Manufacturer: ESEN SKV

• Construction Year to: 05.1996
• Lambda Sensor: Regulating Probe, Finger probe
• Fitting Position: before catalytic converter
• Number of circuits: 4
• Connector/Clamp: Connector may need adjustment
• Transmission Type: Manual Transmission
• Name: LAMBDA ANDUR
• Manufacturer: MAX

• Exhaust System: for pre-catalytic converter
• Quality: OE
• Thread Size: M18x1.5
• Cable Length [mm]: 750
• Number of pins: 4
• Weight [g]: 103
• Gross Weight [g]: 147
• Manufacturer: DENSO
• Lisainfo: DOX-0109 DENSO
• Additional information: DOX-0109 DENSO

Lambda Sensor: Regulating Probe, Heated, Finger probe, Lambda Sensor

• Construction Year to: 05.1996
• Exhaust System: for pre-catalytic converter
• Cable Length [mm]: 580
• Lambda Sensor: Planar probe, Heated
• Manufacturer: DELPHI
• Name: DE ES20076-12B1

• Construction Year to: 05.1996
• Lambda Sensor: Regulating Probe
• Fitting Position: before catalytic converter
• Number of circuits: 4
• Recommended change interval [km]: 160,000
• Connector/Clamp: Connector may need adjustment
• Name: LAMBDA ANDUR
• Manufacturer: BOS

• Cable Length [mm]: 530
• Number of pins: 3
• Manufacturer: ERA

• Number of pins: 3
• Cable Length [mm]: 485
• Name: ANDUR, VŽNTVOLL
• Manufacturer: TRI