Fabrication Number: ECT-CH-006

• Sensor Type: Passive sensor
• for OE number: 9118368
• Manufacturer: KAMOKA

• Sensor Type: Passive sensor
• for OE number: 51271207038
• Manufacturer: KAMOKA

• Sensor Type: NTC Sensor
• Mounting Type: Bolted
• Connector Shape: oval
• Number of pins: 2
• Spanner Size: 19
• Thread Size: M12x1.5
• for OE number: 46462179
• Supplementary Article/Info 2: with seal ring
• Name: Andur,Jahutusvedeliku temp.
• Manufacturer: NRF

• Thread Size: M12x1.5
• Name: ANDUR,JAHUTUSVEDELIKU TEMP.
• Manufacturer: VER

• Connector Shape: oval
• Material: Plastic
• Number of pins: 2
• Plug Type: Female
• Sensor Type: NTC Sensor
• Spanner Size: S19
• Thread Size: M12*1,5
• Name: NI 207019
• Manufacturer: NISSENS

Technical Information: FIRST FIT - a time-saving installation! Find all additional parts such as O-rings, clip, washer in the box.

• Thread Size: M12x1.5
• Spanner Size: 19
• Corresponds to the original part in colour: green, black, grey, white
• Manufacturer: FAST

• Outer Diameter [mm]: 7.4
• Resistor [Ohm]: 2,080, 294
• Supplementary Article/Supplementary Info: with seal
• External Thread [mm]: 12
• Thread Pitch [mm]: 1.5
• Temperature range [°C]: 25, 80
• Mounting Type: Bolted
• Colour: blue
• Spanner Size: 19
• Sensor Type: NTC Sensor
• Number of pins: 2
• Corresponds to the original part in colour: black, white, light blue
• not for trim level: 4mm
• Assy./disassy. by qualified personnel required!:
• Name: ANDUR,JAHUTUSVEDELIKU TEMP.
• Manufacturer: HEL

Brief Information: *** HELLA Electronics OE competence for over 60 years.

• Number of pins: 2
• Thread Size: M12x1,5
• Supplementary Article/Info 2: with seal ring
• Housing Colour: black
• Weight [kg]: 0.032
• Manufacturer: VEMO GERMANY

General Information: In the warranty, we always make a distinction between wear parts and vehicle parts. All wear parts are subject to a reduced warranty period and a maximum mileage. Brake components such as brake disks, brake pads, etc. maximum of 1000 km (break-in period). Therefore, warranty claims for brake parts are only reviewed with an installation invoice and a record of the wheel hub run-out measurement, including photos. For brake disks and brake pads, the break-in requirements specified by the vehicle manufacturer must be observed. When replacing brakes, the chassis components must always be checked with regard to clearance and the wheel hub with regard to wobble, and the appropriate documentation must be produced. If the vehicle is no longer in its original condition due to tuning work such as wheel accessories and tracking plates, the entitlement to make warranty claims is lost due to third-party work. The same warranty claims are lost if the vehicle is used for motor sports or similar events.

• Thread Size: M12 x 1,5
• Number of pins: 2
• Manufacturer: ERA

• Engine Code: B284R
• Thread Size: M12x1,5
• Spanner Size: 19
• Corresponds to the original part in colour: white, green, black
• for article number: 1.880.170, 1.880.190
• Name: ANDUR,JAHUTUSVEDELIKU TEMP.
• Manufacturer: EPS

• Engine Code: B284R
• Sensor Type: NTC Sensor
• Thread Size: M12 x 1,5
• Spanner Size: 19
• Supplementary Article/Info 2: with seal ring
• Colour: grey
• Number of pins: 2
• Name: ANDUR,JAHUTUSVEDELIKU TEMP.
• Manufacturer: MEY

• Number of pins: 2
• Weight [kg]: 0.3
• Packaging length [cm]: 12
• Packaging width [cm]: 8
• Packaging height [cm]: 6

• Number of pins: 3
• Fabrication Number: ECC-PL-004

Manufacturer: MAGNETI MARELLI

• Construction Year to: 06.2012
• Manufacturer: BOSCH

• Construction Year to: 06.2012
• Manufacturer: BOSCH

• Required quantity: 1
• Voltage [V]: 12
• Number of pins: 3
• Sensor Type: Hall Sensor
• Supplementary Article/Info 2: without cable
• Housing Colour: black
• Manufacturer: BREMI

• Number of circuits: 4
• Lambda Sensor: Regulating Probe
• Manufacturer: KAMOKA

• Lambda Sensor: Diagnostic Probe, Thread pre-greased
• Fabrication Number: ESL-SK-000
• Manufacturer: NTY
• Name: NTY ESL-SK-000

• Number of pins: 2
• Name: DE AS10192
• Manufacturer: DELPHI

• Construction Year to: 06.2012
• Name: ANDUR,NUKKVOLLIPOSITSIOON
• Manufacturer: BOS

• Lambda Sensor: Lambda Sensor
• Voltage [V]: 12
• Number of circuits: 4
• Weight [kg]: 0.09
• Resistor [Ohm]: 9
• Operating Mode: Electric
• Warranty: 3 years warranty
• Manufacturer: SKV GERMANY
• Name: CE 09SKV909

• Construction Year to: 06.2012
• Lambda Sensor: Diagnostic Probe, Finger probe
• Fitting Position: after catalytic converter
• Number of circuits: 4
• Connector/Clamp: Connector may need adjustment
• Transmission Type: Manual Transmission
• Name: LAMBDA ANDUR
• Manufacturer: MAX

• Number of pins: 3
• Weight [kg]: 0.024
• Manufacturer: VEMO GERMANY

General Information: In the warranty, we always make a distinction between wear parts and vehicle parts. All wear parts are subject to a reduced warranty period and a maximum mileage. Brake components such as brake disks, brake pads, etc. maximum of 1000 km (break-in period). Therefore, warranty claims for brake parts are only reviewed with an installation invoice and a record of the wheel hub run-out measurement, including photos. For brake disks and brake pads, the break-in requirements specified by the vehicle manufacturer must be observed. When replacing brakes, the chassis components must always be checked with regard to clearance and the wheel hub with regard to wobble, and the appropriate documentation must be produced. If the vehicle is no longer in its original condition due to tuning work such as wheel accessories and tracking plates, the entitlement to make warranty claims is lost due to third-party work. The same warranty claims are lost if the vehicle is used for motor sports or similar events.

• Fitting Position: Front
• Exhaust System: after catalytic converter
• Lambda Sensor: Diagnostic Probe
• Length [mm]: 400
• Number of connectors: 4
• Manufacturer: VERNET

• Lambda Sensor: Diagnostic Probe, Unheated
• Exhaust System: after catalytic converter
• Number of pins: 4
• Cable Length [mm]: 520
• Quality: OE EQUIVALENT
• Manufacturer: MEAT&DORIA

• Lambda Sensor: Diagnostic Probe, Heated
• External Thread Size: M18 x 1,5
• Spanner Size: 22
• Number of circuits: 4
• Cable Length [mm]: 450
• Weight [kg]: 0.087
• Name: SW 33 10 3204
• Manufacturer: SWAG

General Information: These products are designed to be used as originally intended and not modified for purpose. Please ensure the products are installed by a competent individual. N.B. products are usually supplied without fitting instructions.

• Lambda Sensor: Lambda Sensor
• Cable Length [mm]: 290
• Alternatively:
• Number of circuits: 4
• Alternative Repair Kit: 570112
• Manufacturer: ERA

• Lambda Sensor: Diagnostic Probe, Thread pre-greased
• Fitting Position: after catalytic converter
• Line insulation design: with silicone-coated woven-fibre insulation
• Overall Length [mm]: 448
• Weight [kg]: 0.11
• Manufacturer: VEMO GERMANY

General Information: In the warranty, we always make a distinction between wear parts and vehicle parts. All wear parts are subject to a reduced warranty period and a maximum mileage. Brake components such as brake disks, brake pads, etc. maximum of 1000 km (break-in period). Therefore, warranty claims for brake parts are only reviewed with an installation invoice and a record of the wheel hub run-out measurement, including photos. For brake disks and brake pads, the break-in requirements specified by the vehicle manufacturer must be observed. When replacing brakes, the chassis components must always be checked with regard to clearance and the wheel hub with regard to wobble, and the appropriate documentation must be produced. If the vehicle is no longer in its original condition due to tuning work such as wheel accessories and tracking plates, the entitlement to make warranty claims is lost due to third-party work. The same warranty claims are lost if the vehicle is used for motor sports or similar events.

• Construction Year to: 06.2012
• Lambda Sensor: Diagnostic Probe
• Fitting Position: after catalytic converter
• Number of circuits: 4
• Overall Length [mm]: 340
• Available as universal article as well, see article no.: 0258986602
• Recommended change interval [km]: 250,000
• Name: LAMBDA ANDUR
• Manufacturer: BOS

• Construction Year to: 06.2012
• Lambda Sensor: Diagnostic Probe
• Fitting Position: after catalytic converter
• Number of circuits: 4
• Recommended change interval [km]: 160,000
• Connector/Clamp: Connector may need adjustment
• Name: LAMBDA ANDUR
• Manufacturer: BOS

• Engine Code: B284R
• Fitting Position: after catalytic converter
• Cable Length [mm]: 250
• Conductor Number: 4
• Number of circuits: 4
• Name: EP 1.998.235
• Manufacturer: EPS

Lambda Sensor: Diagnostic Probe, Heated, Planar probe, Thread pre-greased

• Quality: OE
• Manufacturer Restriction: DENSO
• Thread Size: M18x1.5
• Cable Length [mm]: 750
• Number of pins: 4
• Weight [g]: 93
• Gross Weight [g]: 140
• Manufacturer: DENSO
• Name: DN DOX-0150
• Quality class: Q

Lambda Sensor: Diagnostic Probe, Heated, Planar probe, Thread pre-greased, Lambda Sensor Additional information: "Tootja: DENSO
(kvaliteediklass: Q)" Lisainfo: "Tootja: DENSO
(kvaliteediklass: Q)"

• for OE number: 93186115
• Quality: OE
• Manufacturer Restriction: DENSO
• Thread Size: M18x1.5
• Cable Length [mm]: 400
• Number of pins: 4
• Weight [g]: 83
• Gross Weight [g]: 116
• Manufacturer: DENSO
• Name: DN DOX-2050

Lambda Sensor: Diagnostic Probe, Heated, Planar probe, Thread pre-greased, Lambda Sensor Additional information: "Tootja: DENSO
CORSA D, 07.06-
(kvaliteediklass: Q)" Lisainfo: "Tootja: DENSO
CORSA D, 07.06-
(kvaliteediklass: Q)"

• Lambda Sensor: Lambda Sensor
• Voltage [V]: 12
• Colour: red
• Number of circuits: 5
• Weight [kg]: 0.15
• Operating Mode: Electric
• Warranty: 3 years warranty
• Manufacturer: SKV GERMANY
• Name: CE 09SKV905

• Lambda Sensor: Regulating Probe, Broadband lambda sensor, Heated
• Exhaust System: for pre-catalytic converter
• Block Separation:
• Fitting Position: before catalytic converter
• Cable Length [mm]: 655
• Name: LAMBDA ANDUR
• Manufacturer: DLP

• Lambda Sensor: Lambda Sensor
• Weight [kg]: 0.15
• Warranty: 3 years warranty
• Technical Information: Universal
• Name: CE 09SKV915
• Manufacturer: ESEN SKV

• Housing Type: with housing
• Number of pins: 5
• Plug Type: Male
• Housing Colour: black
• Voltage [V]: 12
• Recommended additional repairs: Air Filter
• Name: Ohumassimootja
• Manufacturer: DLP

• Construction Year to: 06.2012
• Lambda Sensor: Regulating Probe
• Fitting Position: before catalytic converter
• Number of circuits: 5
• Overall Length [mm]: 684
• Recommended change interval [km]: 250,000
• Manufacturer: BOSCH

• Construction Year to: 06.2012
• Manufacturer: METZGER