Tootekategooriad
Filtrid Pidurid vedrustus/alusvanker Roolisüsteem Jahutus/kliima Elektrisüsteem Veokonks/lisad Jõuülekanne Väljalaskesüsteem Kere Süüte-/eelsüütesüsteem Mootor Klaasid/klaasipuhastus Valgustus Kütus Kabiinivarustus HooldusToode
Kirjeldus
Laoseis
Hind
(km-ga)
- Mootorikood: CRVC
- Kogus pakendis: 25
- Material: Silicone
- Colour: anthracite
- Capacity [ml]: 70
- Temperature range from [°C]: 50
- Temperature range to [°C]: 320
- Packing Type: Tube
-
only in connection with: 70-
31415- 00 -
Nimetus: TIHEND,
KLAPIKAAN - Tootja: REI
-
Lisainfo: RNZ70-
31414- 10
Chemical Properties: not solvent-bearing, Permanently elastic, hardening
- Käigukasti liik: automaatkast 6 käiku
- PR-numbri jaoks: G1A
- Kogus pakendis: 10
- Inner Diameter [mm]: 11.7
- Outer Diameter [mm]: 16.5
- Thickness [mm]: 2.2
- Material: Sheet Steel
- Tootja: TOPRAN
General Information: Any and all spare parts we supply are solely intended for the designated purpose as defined by us. Installation by trained personnel only. Our products are usually supplied without assembly instructions. Installation in vehicles other than those specified by us may lead to the exclusion of warranty.
Tootja: DR MOTOR PRZEWODY PRZELEWOWE
- Mudeliaasta kuni: 2016
- Weight [kg]: 0.001
- Inner Diameter [mm]: 12
- Outer Diameter [mm]: 16
- Packaging length [cm]: 1.7
- Packaging width [cm]: 1.7
- Packaging height [cm]: 0.3
- Tootja: FEBEST
- Kogus pakendis: 12
- Packing Type: Tube
- Capacity [ml]: 70
- Material: Silicone
- Colour: beige
- Observe mounting information:
-
Temperature range from [°C]: -
60 - Temperature range to [°C]: 315
- Available as universal article as well, see article no.: 030.793 Dirko
- Tootja: ELRING
- Lisainfo: 030.793 ELR
Chemical Properties: Permanently elastic, not solvent-bearing, UV resistant
-
Supplementary Article/Info 2: with lid,
with bolts/ screws - Material: Plastic
-
Supplementary Article/Supplementary Info: with gasket/
seal - Vehicle Equipment: for vehicles without oil level sensor
-
Nimetus: TIHENDIKOMPLEKT,
OLIVANN - Tootja: HAN
General Information: Any and all spare parts we supply are solely intended for the designated purpose as defined by us. Installation by trained personnel only. Our products are usually supplied without assembly instructions. Installation in vehicles other than those specified by us may lead to the exclusion of warranty.
- Üldine informatsioon: cover for oil sump; plastic
- Tootja: VIKA
-
Supplementary Article/Info 2: with cap,
with bolts/ screws -
Supplementary Article/Supplementary Info: with gasket/
seal - Vehicle Equipment: for vehicles without oil level sensor
-
Nimetus: Tihendikomplekt,
Olivann - Tootja: MAX
-
Supplementary Article/Info 2: with bolts/
screws - Tootja: JP GROUP
- Mootorikood: CRVC
-
Chemical Properties: not solvent-
bearing - Packing Type: Tube
- Capacity [ml]: 75
- Material: Silicone
-
Temperature range from [°C]: -
60 - Temperature range to [°C]: +320
- Supplementary Article/Info 2: not contained in set
-
Nimetus: TIHEND,
KLAPIKAAN - Tootja: AJU
- Lisainfo: AJU75000200
- Height [mm]: 18.5
- Length [mm]: 65.2
- Width [mm]: 68.2
- Material: Plastic
- Weight [kg]: 0.063
- Tootja: VAICO
Supplementary Article/Info 2: with bolts/screws, with seal ring, with bore for oil-level sensor General Information: In the warranty, we always make a distinction between wear parts and vehicle parts. All wear parts are subject to a reduced warranty period and a maximum mileage. Brake components such as brake disks, brake pads, etc. maximum of 1000 km (break-in period). Therefore, warranty claims for brake parts are only reviewed with an installation invoice and a record of the wheel hub run-out measurement, including photos. For brake disks and brake pads, the break-in requirements specified by the vehicle manufacturer must be observed. When replacing brakes, the chassis components must always be checked with regard to clearance and the wheel hub with regard to wobble, and the appropriate documentation must be produced. If the vehicle is no longer in its original condition due to tuning work such as wheel accessories and tracking plates, the entitlement to make warranty claims is lost due to third-party work. The same warranty claims are lost if the vehicle is used for motor sports or similar events.
- Mootorikood: CRVC
- Forward- /Backflow: for backflow
- Weight [kg]: 0.04
- Tootja: VAICO
General Information: In the warranty, we always make a distinction between wear parts and vehicle parts. All wear parts are subject to a reduced warranty period and a maximum mileage. Brake components such as brake disks, brake pads, etc. maximum of 1000 km (break-in period). Therefore, warranty claims for brake parts are only reviewed with an installation invoice and a record of the wheel hub run-out measurement, including photos. For brake disks and brake pads, the break-in requirements specified by the vehicle manufacturer must be observed. When replacing brakes, the chassis components must always be checked with regard to clearance and the wheel hub with regard to wobble, and the appropriate documentation must be produced. If the vehicle is no longer in its original condition due to tuning work such as wheel accessories and tracking plates, the entitlement to make warranty claims is lost due to third-party work. The same warranty claims are lost if the vehicle is used for motor sports or similar events.
- Mootorikood: CRVC
-
Chemical Properties: not solvent-
bearing - Packing Type: Cartridge
- Capacity [ml]: 200
- Material: Silicone
-
Temperature range from [°C]: -
60 - Temperature range to [°C]: +320
- not for country specific design: USA
- Supplementary Article/Info 2: not contained in set
-
Nimetus: TIHEND,
KLAPIKAAN - Tootja: AJU