Tootekategooriad
Filtrid Pidurid vedrustus/alusvanker Roolisüsteem Jahutus/kliima Elektrisüsteem Veokonks/lisad Jõuülekanne Väljalaskesüsteem Kere Süüte-/eelsüütesüsteem Mootor Klaasid/klaasipuhastus Valgustus Kütus Kabiinivarustus HooldusToode
Kirjeldus
Laoseis
Hind
(km-ga)
- Operating Mode: Electric
- Weight [kg]: 1.5
- Shifting Points [bar]: 1.2
- Pressure [bar]: 3
- Required quantity: 1
- General Information: fuel pump; 3.0 BAR
- Tootja: VIKA
- Voltage [V]: 12
- Fitting Position: in fuel tank
- Diameter [mm]: 43
- Operating Mode: Electric
- Flow rate [l/h]: 70
-
Injection System: Single Point Injection
(SPI) - Supplementary Article/Info 2: with filter
- Weight [kg]: 0.6
- Diameter 1 [mm]: 9
- Diameter 2 [mm]: 51
- Operating Pressure [bar]: 1.2
-
Number of inlets/outlets: 1/
1 - Length 2 [mm]: 141
- Always compare old and new part (in particular OE No.):
- Tootja: ENERGY
- Voltage [V]: 12
- Fitting Position: in fuel tank
- Diameter [mm]: 43
- Operating Mode: Electric
- Flow rate [l/h]: 70
-
Injection System: Single Point Injection
(SPI) - Supplementary Article/Info 2: with filter
- Guarantee: 4 years guarantee
- Weight [kg]: 0.6
- Diameter 1 [mm]: 9
- Diameter 2 [mm]: 51
- Operating Pressure [bar]: 1.2
-
Number of inlets/outlets: 1/
1 - Length 2 [mm]: 141
- Always compare old and new part (in particular OE No.):
- Tootja: SKV GERMANY
- Nimetus: CE 02SKV220
- Operating Mode: Electric
- Flow rate [l/h]: 70
-
Injection System: Single Point Injection
(SPI) - Tootja: KAMOKA
- Operating Mode: Electric
- Pressure [bar]: 1.2
- Lisainfo: Fuel pump with plastic filter
- Operating Mode: Electric
- Pressure [bar]: 1.2
- Flow rate [l/h]: 70
-
Injection System: Single Point Injection
(SPI) - Tootja: MEAT & DORIA
- Operating Mode: Electric
- Pressure [bar]: 3
- Lisainfo: Fuel Pump
- Width [mm]: 115
- Operating Mode: Electric
- Voltage [V]: 12
- Length [mm]: 145
- Height [mm]: 110
- Weight [kg]: 0.602
- Pressure [bar]: 3
- Tootja: VEMO GERMANY
General Information: In the warranty, we always make a distinction between wear parts and vehicle parts. All wear parts are subject to a reduced warranty period and a maximum mileage. Brake components such as brake disks, brake pads, etc. maximum of 1000 km (break-in period). Therefore, warranty claims for brake parts are only reviewed with an installation invoice and a record of the wheel hub run-out measurement, including photos. For brake disks and brake pads, the break-in requirements specified by the vehicle manufacturer must be observed. When replacing brakes, the chassis components must always be checked with regard to clearance and the wheel hub with regard to wobble, and the appropriate documentation must be produced. If the vehicle is no longer in its original condition due to tuning work such as wheel accessories and tracking plates, the entitlement to make warranty claims is lost due to third-party work. The same warranty claims are lost if the vehicle is used for motor sports or similar events.
- Operating Mode: Electric
- Operating Pressure [bar]: 4
- Tootja: JP GROUP
- Lisainfo: Fuel pump with housing
- Mootorikood: 1F
- Pinge [V]: 12
-
Läbimõõt [mm]: 110,
2 - Läbimõõt 1 (mm): 8
-
Kasutusõhk [bar]: 1,
2 - pikkus üle kõige (mm): 140
- Rakendustüüp: elektriline
- Piirangutega toode/piirangu info: ohne Tankgeber
- Ühenduste arv: 1
-
Surve (psi): 17,
4 - Nimetus: Fuel feed unit
- Kvaliteediklass: PJ
Lisainfo: SEAT IBIZA/CORD.,02- (kvaliteediklass PJ)
- Mootorikood: 1F
- Tootja piirang: VDO
- Operating Mode: Electric
- Diameter [mm]: 43
- Total Length [mm]: 140
- Diameter 1 [mm]: 8
- Number of connectors: 1
- Pressure [bar]: 1.2
- Pressure [psi]: 17.4
- Voltage [V]: 12
-
Supplementary Article/Supplementary Info: with holder,
without tank sender unit - Tootja: PIERBURG
- Voltage [V]: 12
- Fitting Position: in fuel tank
- Operating Mode: Electric
- Fuel Type: Petrol
- Guarantee: 4 years guarantee
- Weight [kg]: 1.16
- Always compare old and new part (in particular OE No.):
- Tootja: SKV GERMANY
- Nimetus: CE 02SKV703
- Mootorikood: 1F
- Tootja piirang: VDO
- Operating Mode: Electric
- Diameter [mm]: 110.2
- Total Length [mm]: 140
- Diameter 1 [mm]: 8
- Number of connectors: 1
- Pressure [bar]: 1.2
- Pressure [psi]: 17.4
- Voltage [V]: 12
- Supplementary Article/Supplementary Info: without tank sender unit
- Tootja: PIERBURG
- Pressure [bar]: 1.2
- Operating Mode: Electric
- Weight [kg]: 0.576
- Tootja: VEMO
for article number: V10-09-0801, V10-09-0801-1, V10-09-0826, V10-09-0826-1 General Information: In the warranty, we always make a distinction between wear parts and vehicle parts. All wear parts are subject to a reduced warranty period and a maximum mileage. Brake components such as brake disks, brake pads, etc. maximum of 1000 km (break-in period). Therefore, warranty claims for brake parts are only reviewed with an installation invoice and a record of the wheel hub run-out measurement, including photos. For brake disks and brake pads, the break-in requirements specified by the vehicle manufacturer must be observed. When replacing brakes, the chassis components must always be checked with regard to clearance and the wheel hub with regard to wobble, and the appropriate documentation must be produced. If the vehicle is no longer in its original condition due to tuning work such as wheel accessories and tracking plates, the entitlement to make warranty claims is lost due to third-party work. The same warranty claims are lost if the vehicle is used for motor sports or similar events.
- Width [mm]: 115
- Length [mm]: 103
- Operating Mode: Electric
- Height [mm]: 145
- Weight [kg]: 0.9
- Pressure [bar]: 3
- Number of pins: 2
- Supplementary Article/Info 2: with swirl pot
- Tootja: VEMO
General Information: In the warranty, we always make a distinction between wear parts and vehicle parts. All wear parts are subject to a reduced warranty period and a maximum mileage. Brake components such as brake disks, brake pads, etc. maximum of 1000 km (break-in period). Therefore, warranty claims for brake parts are only reviewed with an installation invoice and a record of the wheel hub run-out measurement, including photos. For brake disks and brake pads, the break-in requirements specified by the vehicle manufacturer must be observed. When replacing brakes, the chassis components must always be checked with regard to clearance and the wheel hub with regard to wobble, and the appropriate documentation must be produced. If the vehicle is no longer in its original condition due to tuning work such as wheel accessories and tracking plates, the entitlement to make warranty claims is lost due to third-party work. The same warranty claims are lost if the vehicle is used for motor sports or similar events.
- Width [mm]: 102
- Length [mm]: 115
- Height [mm]: 145
- Operating Mode: Electric
- Weight [kg]: 0.9
- Pressure [bar]: 1.2
- Supplementary Article/Info 2: with swirl pot
- Tootja: VEMO
General Information: In the warranty, we always make a distinction between wear parts and vehicle parts. All wear parts are subject to a reduced warranty period and a maximum mileage. Brake components such as brake disks, brake pads, etc. maximum of 1000 km (break-in period). Therefore, warranty claims for brake parts are only reviewed with an installation invoice and a record of the wheel hub run-out measurement, including photos. For brake disks and brake pads, the break-in requirements specified by the vehicle manufacturer must be observed. When replacing brakes, the chassis components must always be checked with regard to clearance and the wheel hub with regard to wobble, and the appropriate documentation must be produced. If the vehicle is no longer in its original condition due to tuning work such as wheel accessories and tracking plates, the entitlement to make warranty claims is lost due to third-party work. The same warranty claims are lost if the vehicle is used for motor sports or similar events.
- Fitting Position: in fuel tank
-
Supplementary Article/Supplementary Info: with fastening/
mounting material - Supplementary Article/Info 2: with connector parts
- Operating Mode: Electric
- Tootja: BOSCH
- Width [mm]: 102
- Length [mm]: 115
- Height [mm]: 145
- Operating Mode: Electric
- Weight [kg]: 0.9
- Operating Pressure [bar]: 4
- Supplementary Article/Info 2: with swirl pot
- Tootja: VEMO
General Information: In the warranty, we always make a distinction between wear parts and vehicle parts. All wear parts are subject to a reduced warranty period and a maximum mileage. Brake components such as brake disks, brake pads, etc. maximum of 1000 km (break-in period). Therefore, warranty claims for brake parts are only reviewed with an installation invoice and a record of the wheel hub run-out measurement, including photos. For brake disks and brake pads, the break-in requirements specified by the vehicle manufacturer must be observed. When replacing brakes, the chassis components must always be checked with regard to clearance and the wheel hub with regard to wobble, and the appropriate documentation must be produced. If the vehicle is no longer in its original condition due to tuning work such as wheel accessories and tracking plates, the entitlement to make warranty claims is lost due to third-party work. The same warranty claims are lost if the vehicle is used for motor sports or similar events.
Laki Auto universaaltooted
TecDoc sõidukite kataloog
TecDoc veokite kataloog