Tootekategooriad
Filtrid Pidurid vedrustus/alusvanker Roolisüsteem Jahutus/kliima Elektrisüsteem Veokonks/lisad Jõuülekanne Väljalaskesüsteem Kere Süüte-/eelsüütesüsteem Mootor Klaasid/klaasipuhastus Valgustus Kütus Kabiinivarustus HooldusToode
Kirjeldus
Laoseis
Hind
(km-ga)
-
Mootorikood: DSRA,
CRLB - Kogus pakendis: 50
- External Thread Size: M10 x 1
- Surface: Phosphatized
- Diameter 1 [mm]: 15.5
- Inner length [mm]: 30
- Screw length below head [mm]: 22
- Weight [kg]: 0.02
- Tootja: FEBI
General Information: These products are designed to be used as originally intended and not modified for purpose. Please ensure the products are installed by a competent individual. N.B. products are usually supplied without fitting instructions.
-
Mootorikood: CRLB,
DFGA - Number of bolts/screws: 6
- SVHC: No SVHC present!
- Tootja: LUK
- Nimetus: LU 411013310
-
Mootorikood: DSRA,
CRLB - Number of flywheel screws: 8
- Observe service information:
-
Nimetus: Kruvikomplekt,
hooratas - Tootja: BLP
- Lisainfo: BLPADV183315
General Information: These products are designed to be used as originally intended and not modified for purpose. Please ensure the products are installed by a competent individual. N.B. products are usually supplied without fitting instructions.
-
Mootorikood: DFEA,
DSRB, DTSB, DTSA, DSRA - Number of bolts/screws: 8
- SVHC: No SVHC present!
-
Nimetus: KRUVIKOMPLEKT,
HOORATAS - Tootja: LUK
- Number of flywheel screws: 8
-
Thread Size: M10 x 1,
0 x 22 - DIN/ISO: 34821
- Strength class: 12.9
- Tootja: VAICO
General Information: In the warranty, we always make a distinction between wear parts and vehicle parts. All wear parts are subject to a reduced warranty period and a maximum mileage. Brake components such as brake disks, brake pads, etc. maximum of 1000 km (break-in period). Therefore, warranty claims for brake parts are only reviewed with an installation invoice and a record of the wheel hub run-out measurement, including photos. For brake disks and brake pads, the break-in requirements specified by the vehicle manufacturer must be observed. When replacing brakes, the chassis components must always be checked with regard to clearance and the wheel hub with regard to wobble, and the appropriate documentation must be produced. If the vehicle is no longer in its original condition due to tuning work such as wheel accessories and tracking plates, the entitlement to make warranty claims is lost due to third-party work. The same warranty claims are lost if the vehicle is used for motor sports or similar events.
-
Mootorikood: CRLB,
DFGA, DSRA, DSRB, DTSA, DTSB - Käigukasti liik: Käigukast 6 käiku
-
Engine Features/Arrangement: for engines with dual-
mass flywheel - for flywheel manufacturer: LUK
- Outer Diameter [mm]: 289
- Number of mounting bores: 6
- Supplementary Article/Info 2: with screw set
- Tightening Torque [Nm]: 60
- Tightening angle [degrees]: 90
- for flywheel depth [mm]: 64.23
- Weight [kg]: 12.32
- Nimetus: HOORATAS
- Tootja: VAL
-
Mootorikood: CRLB,
DFGA - Transmission Type: Manual Transmission
- Number of mounting bores: 6
- SVHC: No SVHC present!
- Nimetus: HOORATAS
- Tootja: LUK
- Hammastehulk: 129
- Üldine informatsioon: dual mass flywheel; 129 teeth
- Tootja: BORSEHUNG
- Käigukasti liik: Käigukast 6 käiku
- Tootja piirang: SACHS
- Outer Diameter [mm]: 240
- Supplementary Article/Supplementary Info: with flywheel screws
- Nimetus: HOORATAS
- Tootja: SAC
SVHC: No information available, please contact the manufacturer!
-
Mootorikood: CRLB,
DFEA -
Käigukasti liik: Topeltsiduriajam,
6- käiguline -
Transmission Type: Dual-
Clutch Transmission - Outer Diameter [mm]: 280
-
Supplementary Article/Supplementary Info: with flywheel screws,
without pilot bearing - Nimetus: Hooratas
- Tootja: SAC
- Lisainfo: 2295 001 847
SVHC: No information available, please contact the manufacturer!
- Ehitusaasta kuni: 01.2020
-
Mootorikood: CRLB,
DFGA, DSRA, DTSA -
Kastitüüp: QFZ,
QFZ, ULV - Käigukasti liik: Käigukast 6 käiku
- Plokieraldus:
- New Part:
-
Supplementary Article/Info 2: with screw set,
without sensor - Clutch Pressure Plate Outer Diameter [mm]: 240
-
Preload Force [N]: 7,
200 - Number of Teeth: 23
- Number of mounting bores at central slave cylinder: 3
- Bore Diameter [mm]: 31
- Material: Aluminium
- Weight [kg]: 19.84
- Nimetus: Sidurikomplekt
- Tootja: VAL
Supplementary Article/Supplementary Info: with single-mass flywheel, with central slave cylinder Clutch: Conversion from dual-mass flywheel to single-mass flywheel, for vehicles with push type clutch
- Ehitusaasta kuni: 01.2020
-
Mootorikood: CRLB,
DFGA -
Kastitüüp: QFZ,
QFZ, ULV - Käigukasti liik: Käigukast 6 käiku
- Plokieraldus:
- New Part:
-
Supplementary Article/Supplementary Info: with single-
mass flywheel - Clutch Pressure Plate Outer Diameter [mm]: 240
-
Preload Force [N]: 7,
200 - Number of Teeth: 23
-
Hub Profile: 24,
3 x 21, 8 - Weight [kg]: 19.05
- Tootja: VALEO
Clutch: Conversion from dual-mass flywheel to single-mass flywheel, for vehicles with push type clutch
-
Mootorikood: DFEA,
DSRB, DTSB, DTSA, DSRA - Transmission Type: Manual Transmission
- Number of mounting bores: 8
- SVHC: No SVHC present!
- Nimetus: Hooratas
- Tootja: LUK
-
Transmission Type: 7-
Speed Dual- Clutch Transmission - Clutch Type: for wet clutch
- Number of mounting bores: 6
- SVHC: No SVHC present!
- Nimetus: Hooratas
- Tootja: LUK
- Ehitusaasta kuni: 01.2020
- Mootorikood: CRLB
- Kastitüüp: PZN
-
Käigukasti liik: Topeltsiduriajam,
6- käiguline -
Engine Features/Arrangement: for engines with dual-
mass flywheel - Number of mounting bores: 6
- Weight [kg]: 11.82
- Tootja: VALEO
Laki Auto universaaltooted
TecDoc sõidukite kataloog
TecDoc veokite kataloog