Tootekategooriad
Filtrid Pidurid vedrustus/alusvanker Roolisüsteem Jahutus/kliima Elektrisüsteem Veokonks/lisad Jõuülekanne Väljalaskesüsteem Kere Süüte-/eelsüütesüsteem Mootor Klaasid/klaasipuhastus Valgustus Kütus Kabiinivarustus HooldusToode
Kirjeldus
Laoseis
Hind
(km-ga)
Inner Diameter [mm]: 32
- Material: Stainless Steel
- Tootja: FA1
-
Mootorikood: BMN,
CEGA - Thickness [mm]: 1
- Width [mm]: 46
- Length [mm]: 76
- Tootja: AJUSA
- Fitting Position: Lower
- Gasket Design: Fibre Composite
- Chemical Properties: Asbestos Free
- Mounting Type: Flange mounting
- Number of flange connections: 2
- Tootja: TOPRAN
General Information: Any and all spare parts we supply are solely intended for the designated purpose as defined by us. Installation by trained personnel only. Our products are usually supplied without assembly instructions. Installation in vehicles other than those specified by us may lead to the exclusion of warranty.
- Garantii: 3 aastat garantii
-
Kaal (kg): 0,
01 - Oluline on võrrelda vana uue osaga (eriti OE-numbrit):
- Tootja: ESEN SKV
- Inner Diameter [mm]: 32
- Tootja: FA1
- Kogus pakendis: 10
- Gasket Design: Steel
- Mounting Type: Flange mounting
- Flange Hole Diameter [mm]: 25
- Number of flange connections: 2
- Tootja: TOPRAN
General Information: Any and all spare parts we supply are solely intended for the designated purpose as defined by us. Installation by trained personnel only. Our products are usually supplied without assembly instructions. Installation in vehicles other than those specified by us may lead to the exclusion of warranty.
- Kogus pakendis: 5
- Inner Diameter [mm]: 32
- Tootja: ELRING
- Lisainfo: 729.970 ELR
- Inner Diameter [mm]: 22
- Tootja: ELRING
- Weight [kg]: 0.007
- Tootja: VEMO GERMANY
General Information: In the warranty, we always make a distinction between wear parts and vehicle parts. All wear parts are subject to a reduced warranty period and a maximum mileage. Brake components such as brake disks, brake pads, etc. maximum of 1000 km (break-in period). Therefore, warranty claims for brake parts are only reviewed with an installation invoice and a record of the wheel hub run-out measurement, including photos. For brake disks and brake pads, the break-in requirements specified by the vehicle manufacturer must be observed. When replacing brakes, the chassis components must always be checked with regard to clearance and the wheel hub with regard to wobble, and the appropriate documentation must be produced. If the vehicle is no longer in its original condition due to tuning work such as wheel accessories and tracking plates, the entitlement to make warranty claims is lost due to third-party work. The same warranty claims are lost if the vehicle is used for motor sports or similar events.
- Mootorikood: BMN
-
Shape: O-
Ring - Cooling Hose: from auxiliary water pump to crankcase
- Diameter [mm]: 55.2
- Fitting Position: Throttle Valve at EGR valve
- Thickness [mm]: 2.62
- Weight [kg]: 0.002
- Tootja: VEMO
General Information: In the warranty, we always make a distinction between wear parts and vehicle parts. All wear parts are subject to a reduced warranty period and a maximum mileage. Brake components such as brake disks, brake pads, etc. maximum of 1000 km (break-in period). Therefore, warranty claims for brake parts are only reviewed with an installation invoice and a record of the wheel hub run-out measurement, including photos. For brake disks and brake pads, the break-in requirements specified by the vehicle manufacturer must be observed. When replacing brakes, the chassis components must always be checked with regard to clearance and the wheel hub with regard to wobble, and the appropriate documentation must be produced. If the vehicle is no longer in its original condition due to tuning work such as wheel accessories and tracking plates, the entitlement to make warranty claims is lost due to third-party work. The same warranty claims are lost if the vehicle is used for motor sports or similar events.
- Kogus pakendis: 5
- Fitting Position: Throttle Housing
- Inner Diameter [mm]: 55
- Outer Diameter [mm]: 59
- Thickness [mm]: 4.6
-
Material: FPM
(fluoride rubber) - Shape: A Shape
- Colour: red
- Tootja: ELRING
for OE number: 03G 128 063 G, 03G 128 063 M, 03G 128 063 Q, 03L 128 063 AC, 03L 128 063 E, 03L 128 063 G, 03L 128 063 J, 03L 128 063 L, 03L 128 063 M, 03L 128 063 Q, 03L 128 063 R, A2C59512935, A2C59514304
- Välisläbimõõt [mm]: 59
-
Jämedus/Tugevus (mm): 4,
6 - Installatsiooni pool: Drosselklapi korpus
- Siseläbimõõt [mm]: 55
- Tootja: DR MOTOR PRZEWODY PRZELEWOWE
-
Fitting Position: Throttle Housing,
Throttle Valve at EGR valve - Material: Rubber
- Colour: black
-
Lisainfo: Seal,
EGR valve
- Mootorikood: BMN
-
Kerenumber (VIN) alates: 1Z-
7A153 101 -
Kerenumber (VIN) kuni: 1Z-
82046 951 -
for article number: V10-
63- 0076 - Weight [kg]: 0.003
- Tootja: VEMO GERMANY
General Information: In the warranty, we always make a distinction between wear parts and vehicle parts. All wear parts are subject to a reduced warranty period and a maximum mileage. Brake components such as brake disks, brake pads, etc. maximum of 1000 km (break-in period). Therefore, warranty claims for brake parts are only reviewed with an installation invoice and a record of the wheel hub run-out measurement, including photos. For brake disks and brake pads, the break-in requirements specified by the vehicle manufacturer must be observed. When replacing brakes, the chassis components must always be checked with regard to clearance and the wheel hub with regard to wobble, and the appropriate documentation must be produced. If the vehicle is no longer in its original condition due to tuning work such as wheel accessories and tracking plates, the entitlement to make warranty claims is lost due to third-party work. The same warranty claims are lost if the vehicle is used for motor sports or similar events.
-
Mootorikood: BMN,
CEGA - Nimetus: FI KG110045E
- Tootja: FA1
-
Mootorikood: BMN,
CEGA - Kogus pakendis: 100
- Inner Diameter [mm]: 61
- Thickness [mm]: 3
-
Material: NBR
(nitrile butadiene rubber) -
Shape: O-
Ring - Fitting Position: EGR valve at manifold
-
Mootorikood: BMN,
CEGA - Kogus pakendis: 5
- Inner Diameter [mm]: 61
- Thickness [mm]: 3
-
Material: NBR
(nitrile butadiene rubber) -
Shape: O-
Ring - Fitting Position: EGR valve at manifold
- Alternatively: