Tootekategooriad
Filtrid Pidurid vedrustus/alusvanker Roolisüsteem Jahutus/kliima Elektrisüsteem Veokonks/lisad Jõuülekanne Väljalaskesüsteem Kere Süüte-/eelsüütesüsteem Mootor Klaasid/klaasipuhastus Valgustus Kütus Kabiinivarustus HooldusToode
Kirjeldus
Laoseis
Hind
(km-ga)
- Pinge [V]: 12
- Installatsiooni pool: ees
-
Pikkus (mm): 35,
4 - Laius (mm): 47
-
Kõrgus (mm): 113,
7 -
Kaal (kg): 0,
088 - Rakendustüüp: elektriline
- Sõidukivarustus: sõidukitele ilma Checkkontrollsystem
- Pumbatüüp: Membraanpump
- Tootja: VEMO
Üldine informatsioon: In the warranty, we always make a distinction between wear parts and vehicle parts. All wear parts are subject to a reduced warranty period and a maximum mileage. Brake components such as brake disks, brake pads, etc. maximum of 1000 km (break-in period). Therefore, warranty claims for brake parts are only reviewed with an installation invoice and a record of the wheel hub run-out measurement, including photos. For brake disks and brake pads, the break-in requirements specified by the vehicle manufacturer must be observed. When replacing brakes, the chassis components must always be checked with regard to clearance and the wheel hub with regard to wobble, and the appropriate documentation must be produced. If the vehicle is no longer in its original condition due to tuning work such as wheel accessories and tracking plates, the entitlement to make warranty claims is lost due to third-party work. The same warranty claims are lost if the vehicle is used for motor sports or similar events.
- Rakendustüüp: elektriline
- Pumbatüüp: Monopump
- Pistikkontaktide arv: 2
-
Lisainfo: Washer pump,
headlight cleaning
- Pinge [V]: 12
- Rakendustüüp: elektriline
- Pistikkontaktide arv: 2
-
Kaal (kg): 0,
09 - Tootja: VEMO
Üldine informatsioon: In the warranty, we always make a distinction between wear parts and vehicle parts. All wear parts are subject to a reduced warranty period and a maximum mileage. Brake components such as brake disks, brake pads, etc. maximum of 1000 km (break-in period). Therefore, warranty claims for brake parts are only reviewed with an installation invoice and a record of the wheel hub run-out measurement, including photos. For brake disks and brake pads, the break-in requirements specified by the vehicle manufacturer must be observed. When replacing brakes, the chassis components must always be checked with regard to clearance and the wheel hub with regard to wobble, and the appropriate documentation must be produced. If the vehicle is no longer in its original condition due to tuning work such as wheel accessories and tracking plates, the entitlement to make warranty claims is lost due to third-party work. The same warranty claims are lost if the vehicle is used for motor sports or similar events.
- Pumbatüüp: Monopump
- Pinge [V]: 12
- Ühenduste arv: 2
- Materjal: Plastik
-
Kaal (kg): 0,
175 - Tootja: FEBI
- Lisainfo: F26274
Üldine informatsioon: These products are designed to be used as originally intended and not modified for purpose. Please ensure the products are installed by a competent individual. N.B. products are usually supplied without fitting instructions.
- Mudeliaasta kuni: 2010
- Rakendustüüp: elektriline
- Pumbatüüp: Monopump
- Pinge [V]: 12
- Väljalase-Ø (mm): 7
- Pistikkontaktide arv: 2
- Tootja: MEYLE
- Lisainfo: 3130670001
- Rakendustüüp: elektriline
- Pinge [V]: 12
- Installatsiooni pool: ees
- Pikkus (mm): 150
- Pistikkontaktide arv: 2
- Ühenduste arv: 2
- Etteanne (l/h): 372
-
Kaal (kg): 0,
16 - Tootja: VEMO GERMANY
Üldine informatsioon: In the warranty, we always make a distinction between wear parts and vehicle parts. All wear parts are subject to a reduced warranty period and a maximum mileage. Brake components such as brake disks, brake pads, etc. maximum of 1000 km (break-in period). Therefore, warranty claims for brake parts are only reviewed with an installation invoice and a record of the wheel hub run-out measurement, including photos. For brake disks and brake pads, the break-in requirements specified by the vehicle manufacturer must be observed. When replacing brakes, the chassis components must always be checked with regard to clearance and the wheel hub with regard to wobble, and the appropriate documentation must be produced. If the vehicle is no longer in its original condition due to tuning work such as wheel accessories and tracking plates, the entitlement to make warranty claims is lost due to third-party work. The same warranty claims are lost if the vehicle is used for motor sports or similar events.
- Pumbatüüp: Monopump
-
Surve (bar): 2,
5 - Etteanne (l/h): 432
- Pinge [V]: 12
- Rakendustüüp: elektriline
-
Kaal (kg): 0,
155 - Tootja: VEMO
Üldine informatsioon: In the warranty, we always make a distinction between wear parts and vehicle parts. All wear parts are subject to a reduced warranty period and a maximum mileage. Brake components such as brake disks, brake pads, etc. maximum of 1000 km (break-in period). Therefore, warranty claims for brake parts are only reviewed with an installation invoice and a record of the wheel hub run-out measurement, including photos. For brake disks and brake pads, the break-in requirements specified by the vehicle manufacturer must be observed. When replacing brakes, the chassis components must always be checked with regard to clearance and the wheel hub with regard to wobble, and the appropriate documentation must be produced. If the vehicle is no longer in its original condition due to tuning work such as wheel accessories and tracking plates, the entitlement to make warranty claims is lost due to third-party work. The same warranty claims are lost if the vehicle is used for motor sports or similar events.
- Installatsiooni pool: paremal
- Üldine informatsioon: Headlight spray actuator; right
- Tootja: VIKA
- Rakendustüüp: elektriline
- Pinge [V]: 12
- Pistikkontaktide arv: 2
- Pumbatüüp: Monopump
- Ühendus/klemm: vajadusel kohandada pistikühendus
- Tootja: AIC
Üldine informatsioon: Our products are usually delivered without installation instructions. Installation may only be carried out by trained specialist technicians. Products supplied by us are exclusively intended for proper and appropriate use. The warranty is void in the event of improper, contrary to the intended purpose or unsuitable application or use. For electronic items that leave fault memory entries, it is essential to submit fault memory logs in the event of a claim. This consequently concerns all electronic items that are detected, monitored and controlled by the engine control unit, such as sensors of all kinds (e.g. NOX sensors, ABS sensors), mass airflow sensors, airbag slip rings, headlamp levelling control units, throttle valves, lambda sensors or EGR modules. If you encounter difficulties during a repair (troubleshooting max. 1 hr.), please contact technical support at: Phone: 040 - 25 30 66 55 Email: service@aic-germany.de This often avoids extensive troubleshooting that is disproportionate to normal repair times. The following applies to complaints: The more complete the processes are submitted, the faster they can be processed. Complete documentation includes the warranty application (incl. KBA no., chassis no., first registration, engine code, mileage), first and second installation invoice, fault memory log, guided troubleshooting and, if applicable, pictures. Incomplete documentation may result in rejection of the claim.
- Sõidukivarustus: tulepesuriga sõidukile
- Tootmise kuupäev alates: 2011
- tootmise kuupäev kuni: 2015
-
paaris tootenumbrid: V10-
08- 0509 - Installatsiooni pool: paremal
- Tootja: VEMO GERMANY
Üldine informatsioon: In the warranty, we always make a distinction between wear parts and vehicle parts. All wear parts are subject to a reduced warranty period and a maximum mileage. Brake components such as brake disks, brake pads, etc. maximum of 1000 km (break-in period). Therefore, warranty claims for brake parts are only reviewed with an installation invoice and a record of the wheel hub run-out measurement, including photos. For brake disks and brake pads, the break-in requirements specified by the vehicle manufacturer must be observed. When replacing brakes, the chassis components must always be checked with regard to clearance and the wheel hub with regard to wobble, and the appropriate documentation must be produced. If the vehicle is no longer in its original condition due to tuning work such as wheel accessories and tracking plates, the entitlement to make warranty claims is lost due to third-party work. The same warranty claims are lost if the vehicle is used for motor sports or similar events.
- Ehitusaasta kuni: 12.2010
- Pinge [V]: 12
- Rakendustüüp: elektriline
- Pumbatüüp: Monopump
- Pistikute teostus: Lamepistik
- Monteerimist/demonteerimist peab tegema spetsialist!:
- Tootja: HELLA
- Rakendustüüp: elektriline
- Pumbatüüp: Monopump
- Installatsiooni pool: ees
- soovitava lisavarustuse artiklinumber: 2324118
- Tootja: METZGER
- Pinge [V]: 12
- Pistikuteostus-ID: 3b
- Pumbatüüp: Monopump
- Jälgige sõidukitootja juhiseid:
- Oluline on võrrelda vana uue osaga (eriti OE-numbrit):
- Tootja: VDO
- Operating Mode: Electric
- Pump Type: Mono Pump
- Width [mm]: 65
- Height [mm]: 68
- Length [mm]: 207
- Weight [g]: 220
- Guarantee: 3 years guarantee
- for OE number: 6R0 955 681
- Tootja: AT AUTOTEILE GERMANY
General Information: Products and spare parts supplied by us are only intended for the designated use. Installation may only be carried out by trained specialist personnel. Our products are not always supplied with installation instructions. Improper installation or inappropriate use may lead to the exclusion of warranty.
- Pinge [V]: 12
- Rakendustüüp: elektriline
- Pumbatüüp: Monopump
- Pistikkontaktide arv: 2
-
Kaal (kg): 0,
16 - Tootja: VEMO
Üldine informatsioon: In the warranty, we always make a distinction between wear parts and vehicle parts. All wear parts are subject to a reduced warranty period and a maximum mileage. Brake components such as brake disks, brake pads, etc. maximum of 1000 km (break-in period). Therefore, warranty claims for brake parts are only reviewed with an installation invoice and a record of the wheel hub run-out measurement, including photos. For brake disks and brake pads, the break-in requirements specified by the vehicle manufacturer must be observed. When replacing brakes, the chassis components must always be checked with regard to clearance and the wheel hub with regard to wobble, and the appropriate documentation must be produced. If the vehicle is no longer in its original condition due to tuning work such as wheel accessories and tracking plates, the entitlement to make warranty claims is lost due to third-party work. The same warranty claims are lost if the vehicle is used for motor sports or similar events.
Laki Auto universaaltooted
TecDoc sõidukite kataloog
TecDoc veokite kataloog