Tootekategooriad
Filtrid Pidurid vedrustus/alusvanker Roolisüsteem Jahutus/kliima Elektrisüsteem Veokonks/lisad Jõuülekanne Väljalaskesüsteem Kere Süüte-/eelsüütesüsteem Mootor Klaasid/klaasipuhastus Valgustus Kütus Kabiinivarustus HooldusToode
Kirjeldus
Laoseis
Hind
(km-ga)
- Number of connectors: 4
Lisainfo: Relay for fuel pump and intake manifold heating, 12 Volt, 40 Amp
- Thickness [mm]: 2
- Inner Diameter [mm]: 31
- Outer Diameter [mm]: 35
-
Material: FKM
(fluorocarbon rubber) -
Shape: O-
Ring - Weight [kg]: 0.001
-
Nimetus: Tihend,
ktusepump - Tootja: FEB
- Kogus pakendis: 10
General Information: These products are designed to be used as originally intended and not modified for purpose. Please ensure the products are installed by a competent individual. N.B. products are usually supplied without fitting instructions.
- Siseläbimõõt [mm]: 31
- Jämedus/Tugevus (mm): 2
-
Materjal: FPM
(Fluor- Kautschuk) - Tootja: METZGER
-
Kaal (kg): 0,
035 - vajaminev tükihulk: 1
- Ühenduste arv: 4
- Üldine informatsioon: fuel pump relay
- Tootja: VIKA
- Thickness [mm]: 2
- Inner Diameter [mm]: 31.5
-
Shape: O-
Ring -
Nimetus: Tihend,
ktusepump - Tootja: DRM
- Kogus pakendis: 25
- Inner Diameter [mm]: 31.5
- Outer Diameter [mm]: 35.5
- Thickness [mm]: 2
-
Material: FPM
(fluoride rubber) -
Shape: O-
Ring - Tootja: ELRING
- Pinge [V]: 12
- Pistikkontaktide arv: 4
- Kasutuspinge 12V: 40A
- Tootja: AIC
Üldine informatsioon: Our products are usually delivered without installation instructions. Installation may only be carried out by trained specialist technicians. Products supplied by us are exclusively intended for proper and appropriate use. The warranty is void in the event of improper, contrary to the intended purpose or unsuitable application or use. For electronic items that leave fault memory entries, it is essential to submit fault memory logs in the event of a claim. This consequently concerns all electronic items that are detected, monitored and controlled by the engine control unit, such as sensors of all kinds (e.g. NOX sensors, ABS sensors), mass airflow sensors, airbag slip rings, headlamp levelling control units, throttle valves, lambda sensors or EGR modules. If you encounter difficulties during a repair (troubleshooting max. 1 hr.), please contact technical support at: Phone: 040 - 25 30 66 55 Email: service@aic-germany.de This often avoids extensive troubleshooting that is disproportionate to normal repair times. The following applies to complaints: The more complete the processes are submitted, the faster they can be processed. Complete documentation includes the warranty application (incl. KBA no., chassis no., first registration, engine code, mileage), first and second installation invoice, fault memory log, guided troubleshooting and, if applicable, pictures. Incomplete documentation may result in rejection of the claim.
-
Nimetus: RELEE,
KTUSEPUMP - Tootja: MAX
- General Information: relay
- Tootja: BORSEHUNG
- General Information: relay
- Tootja: BORSEHUNG
-
Relay Number: 67,
80, 167 - Number of connectors: 4
- Weight [kg]: 0.035
-
Nimetus: RELEE,
KTUSEPUMP - Tootja: FEB
General Information: These products are designed to be used as originally intended and not modified for purpose. Please ensure the products are installed by a competent individual. N.B. products are usually supplied without fitting instructions.
- Inner Diameter [mm]: 114
-
Material: NBR
(nitrile butadiene rubber) - Fitting Position: in fuel tank
- Colour: black
- Fuel Supply: Fit together with the fuel feed unit
- Tootja: ELRING
- Current Strength [A]: 40
-
Relay function: Terminal 30,
Clamp 87 - Rated current [A]: 40
- Weight [kg]: 0.04
- Tootja: VEMO
General Information: In the warranty, we always make a distinction between wear parts and vehicle parts. All wear parts are subject to a reduced warranty period and a maximum mileage. Brake components such as brake disks, brake pads, etc. maximum of 1000 km (break-in period). Therefore, warranty claims for brake parts are only reviewed with an installation invoice and a record of the wheel hub run-out measurement, including photos. For brake disks and brake pads, the break-in requirements specified by the vehicle manufacturer must be observed. When replacing brakes, the chassis components must always be checked with regard to clearance and the wheel hub with regard to wobble, and the appropriate documentation must be produced. If the vehicle is no longer in its original condition due to tuning work such as wheel accessories and tracking plates, the entitlement to make warranty claims is lost due to third-party work. The same warranty claims are lost if the vehicle is used for motor sports or similar events.
- Voltage [V]: 12
- Current Strength [A]: 20
- Number of pins: 4
- Tootja: MEAT&DORIA
- Voltage [V]: 12
- Current Strength [A]: 30
- Number of pins: 4
- Relay Number: 449
- Supplementary Article/Info 2: with resistor
- Housing Colour: black
- Tootja: VEMO
Relay function: Trumpet Horns, Low Beam, Interior Blower, Starter, Fuel Pump, Radiator Fan Overrun General Information: In the warranty, we always make a distinction between wear parts and vehicle parts. All wear parts are subject to a reduced warranty period and a maximum mileage. Brake components such as brake disks, brake pads, etc. maximum of 1000 km (break-in period). Therefore, warranty claims for brake parts are only reviewed with an installation invoice and a record of the wheel hub run-out measurement, including photos. For brake disks and brake pads, the break-in requirements specified by the vehicle manufacturer must be observed. When replacing brakes, the chassis components must always be checked with regard to clearance and the wheel hub with regard to wobble, and the appropriate documentation must be produced. If the vehicle is no longer in its original condition due to tuning work such as wheel accessories and tracking plates, the entitlement to make warranty claims is lost due to third-party work. The same warranty claims are lost if the vehicle is used for motor sports or similar events.
- Outer Diameter [mm]: 25.56
- Height [mm]: 29.22
- Fitting Position: Cylinder Head
- Tootja: TOPRAN
General Information: Any and all spare parts we supply are solely intended for the designated purpose as defined by us. Installation by trained personnel only. Our products are usually supplied without assembly instructions. Installation in vehicles other than those specified by us may lead to the exclusion of warranty.
- Outer Diameter [mm]: 26
- Weight [kg]: 0.049
- General Information: tappet
- Tootja: BORSEHUNG
-
Nimetus: POPYCHACZ POMPY WTR. VW TSI 04-
- Tootja: DRM
- Voltage [V]: 12
- Assy./disassy. by qualified personnel required!:
- Tootja: HELLA
- Nimetus: HE 4RP008189151
Brief Information: *** HELLA Electronics OE competence for over 60 years.
- vajaminev tükihulk: 1
- Diameter [mm]: 25.56
- Height [mm]: 29.22
- SVHC: No SVHC present!
-
Nimetus: TOUKUR,
KORGSURVEPUMP - Tootja: INA
- Additionally required articles (article numbers): 133056
- Guarantee: 5 years guarantee
-
General Information: Sold in Hueco brand:
printing and packaging - Tootja: HUCO
for article number: 133061, 133062, 133063, 133064, 133069, 133070, 133071, 133072, 133082
- Üldine informatsioon: Fuel pump control unit;Short term; routine
- Tootja: VIKA
- Voltage [V]: 12
- for OE number: 1T0 906 093 G
- Number of pins: 5
- Tootja: TRUCKTEC
- Üldine informatsioon: control unit for fuel pump; STO
- Tootja: VIKA
- General Information: control unit for fuel pump
- Tootja: BORSEHUNG
- Housing Colour: black
- Guarantee: 5 years guarantee
-
General Information: Sold in Hueco brand:
printing and packaging -
Nimetus: Juhtseade,
ktusepump - Tootja: HUC
- for OE number: 1K0 906 093 J
-
Nimetus: JUHTSEADE,
KTUSEPUMP - Tootja: PIE
- Voltage [V]: 12
- Number of pins: 5
- Number of connectors: 8
- Rated current [A]: 10
- Weight [kg]: 0.17
- Tootja: VEMO
General Information: In the warranty, we always make a distinction between wear parts and vehicle parts. All wear parts are subject to a reduced warranty period and a maximum mileage. Brake components such as brake disks, brake pads, etc. maximum of 1000 km (break-in period). Therefore, warranty claims for brake parts are only reviewed with an installation invoice and a record of the wheel hub run-out measurement, including photos. For brake disks and brake pads, the break-in requirements specified by the vehicle manufacturer must be observed. When replacing brakes, the chassis components must always be checked with regard to clearance and the wheel hub with regard to wobble, and the appropriate documentation must be produced. If the vehicle is no longer in its original condition due to tuning work such as wheel accessories and tracking plates, the entitlement to make warranty claims is lost due to third-party work. The same warranty claims are lost if the vehicle is used for motor sports or similar events.
Laki Auto universaaltooted
TecDoc sõidukite kataloog
TecDoc veokite kataloog