Tootekategooriad
Filtrid Pidurid vedrustus/alusvanker Roolisüsteem Jahutus/kliima Elektrisüsteem Veokonks/lisad Jõuülekanne Väljalaskesüsteem Kere Süüte-/eelsüütesüsteem Mootor Klaasid/klaasipuhastus Valgustus Kütus Kabiinivarustus HooldusToode
Kirjeldus
Laoseis
Hind
(km-ga)
- Installatsiooni pool: Esisild
- Üldine informatsioon: Oil seal for transmission
- Tootja: VIKA
-
Installatsiooni pool: vasakul,
paremal - Plokieraldus:
- Inner Diameter [mm]: 60
- Outer Diameter [mm]: 74.3
- Height [mm]: 8
-
Material: ACM
(Polyacrylate) - Dust Cover: with dust lip
- Swirl Type: Alternating Twist
-
Nimetus: Volli rongastihend,
diferentsiaal - Tootja: HAN
Käigukasti liik: Käigukast 5 käiku, Käigukast 6 käiku, Topeltsiduriajam, 6-käiguline, 7-käiguline Käigukasti ID: GVV, HBM, JHY, GRF, GVT, HDV, HVS, JLW, JQN, JLU, JMA General Information: Any and all spare parts we supply are solely intended for the designated purpose as defined by us. Installation by trained personnel only. Our products are usually supplied without assembly instructions. Installation in vehicles other than those specified by us may lead to the exclusion of warranty.
- Fitting Position: Right
- Height [mm]: 8
- Inner Diameter [mm]: 50
- Outer Diameter [mm]: 65
-
Fabrication Number: NUP-
VW- 031 - Tootja: NTY
-
Nimetus: NTY NUP-
VW- 031
Tavatellimus saadetakse E, K ja R kell 14:00. Kaup saabub kuni 3'e tööpäevaga. Tavatellimusse lähevad ainult positiivse laojäägiga tooted. Lisaks tavatellimusele on võimalik tellida ka Express kulleriga (24h). Kulleri hinda täpsusta 6 599 702, malva@lakiauto.ee.
- Fitting Position: Drive Axle
- Nimetus: SIMER. 50X65X8
- Tootja: DRM
-
Installatsiooni pool: vasakul,
paremal - Plokieraldus:
-
Kerenumber (VIN) alates: 1K-
8- 000001 - Inner Diameter [mm]: 48
- Outer Diameter [mm]: 62
- Height [mm]: 7
-
Material: ACM
(Polyacrylate) - Dust Cover: with dust lip
- Swirl Type: Alternating Twist
-
Nimetus: Volli rongastihend,
diferentsiaal - Tootja: HAN
Käigukasti liik: Käigukast 5 käiku, Käigukast 6 käiku, Topeltsiduriajam, 7-käiguline General Information: Any and all spare parts we supply are solely intended for the designated purpose as defined by us. Installation by trained personnel only. Our products are usually supplied without assembly instructions. Installation in vehicles other than those specified by us may lead to the exclusion of warranty.
- Fitting Position: both sides
-
Fabrication Number: NUP-
VW- 028 - Thickness [mm]: 9
- Inner Diameter [mm]: 39
- Outer Diameter [mm]: 63
- Swirl Type: Alternating Twist
-
Material: FPM
(fluoride rubber) - Dust Cover: with dust lip
- Tootja: NTY
Tavatellimus saadetakse E, K ja R kell 14:00. Kaup saabub kuni 3'e tööpäevaga. Tavatellimusse lähevad ainult positiivse laojäägiga tooted. Lisaks tavatellimusele on võimalik tellida ka Express kulleriga (24h). Kulleri hinda täpsusta 6 599 702, malva@lakiauto.ee.
- Height [mm]: 8
- Inner Diameter [mm]: 50
- Outer Diameter [mm]: 65
-
Material: ACM
(Polyacrylate) - Fitting Position: Right
- Weight [kg]: 0.02
-
Nimetus: Volli rongastihend,
diferentsiaal - Tootja: FEB
General Information: These products are designed to be used as originally intended and not modified for purpose. Please ensure the products are installed by a competent individual. N.B. products are usually supplied without fitting instructions.
-
Kastitüüp: FXQ/
JHU - Installatsiooni pool: paremal
- Käigukasti liik: käigukasti jaoks
- Fitting Position: Front Axle
- Tootja: VAICO
General Information: In the warranty, we always make a distinction between wear parts and vehicle parts. All wear parts are subject to a reduced warranty period and a maximum mileage. Brake components such as brake disks, brake pads, etc. maximum of 1000 km (break-in period). Therefore, warranty claims for brake parts are only reviewed with an installation invoice and a record of the wheel hub run-out measurement, including photos. For brake disks and brake pads, the break-in requirements specified by the vehicle manufacturer must be observed. When replacing brakes, the chassis components must always be checked with regard to clearance and the wheel hub with regard to wobble, and the appropriate documentation must be produced. If the vehicle is no longer in its original condition due to tuning work such as wheel accessories and tracking plates, the entitlement to make warranty claims is lost due to third-party work. The same warranty claims are lost if the vehicle is used for motor sports or similar events.
- Hulk: 1
- Installatsiooni pool: väljas kastipoolne
- Üldine informatsioon: Oil seal for differential shaft
- Tootja: VIKA
- Üldine informatsioon: Damping ring for differential; small
- Tootja: VIKA
-
Installatsiooni pool: Esisild,
Väljapääs, vasakul - Height 1 [mm]: 8
- Outer Diameter 1 [mm]: 74
- Inner Diameter 1 [mm]: 60
-
Material: ACM
(Polyacrylate) - Swirl Type: Alternating Twist
- Dust Cover: with dust lip
-
Nimetus: VOLLI RONGASTIHEND,
DIFERENTSIAAL - Tootja: COT
- Installatsiooni pool: vasakul
- Käigukasti liik: Käigukast 5 käiku
- Fitting Position: front propshaft at differential
- Thickness [mm]: 8
- Inner Diameter [mm]: 60
- Outer Diameter [mm]: 74
- Tootja: VAICO
General Information: In the warranty, we always make a distinction between wear parts and vehicle parts. All wear parts are subject to a reduced warranty period and a maximum mileage. Brake components such as brake disks, brake pads, etc. maximum of 1000 km (break-in period). Therefore, warranty claims for brake parts are only reviewed with an installation invoice and a record of the wheel hub run-out measurement, including photos. For brake disks and brake pads, the break-in requirements specified by the vehicle manufacturer must be observed. When replacing brakes, the chassis components must always be checked with regard to clearance and the wheel hub with regard to wobble, and the appropriate documentation must be produced. If the vehicle is no longer in its original condition due to tuning work such as wheel accessories and tracking plates, the entitlement to make warranty claims is lost due to third-party work. The same warranty claims are lost if the vehicle is used for motor sports or similar events.
-
Installatsiooni pool: Väljapääs,
paremal -
Kastitüüp: FXQ,
JHU - Height 1 [mm]: 8
- Outer Diameter 1 [mm]: 65
- Inner Diameter 1 [mm]: 50
-
Material: ACM
(Polyacrylate) - Swirl Type: Alternating Twist
- Dust Cover: with dust lip
-
Nimetus: VOLLI RONGASTIHEND,
DIFERENTSIAAL - Tootja: COT
-
Installatsiooni pool: vasakul,
paremal -
Käigukasti liik: automaatkastile,
6 käiku - Inner Diameter [mm]: 39
- Outer Diameter [mm]: 63
- Height [mm]: 8.6
-
Material: ACM
(Polyacrylate) - Dust Cover: with dust lip
- Tootja: TOPRAN
General Information: Any and all spare parts we supply are solely intended for the designated purpose as defined by us. Installation by trained personnel only. Our products are usually supplied without assembly instructions. Installation in vehicles other than those specified by us may lead to the exclusion of warranty.
- Käigukasti liik: Käigukast 5 käiku
- Installatsiooni pool: Esisild
- Inner Diameter [mm]: 60
- Outer Diameter [mm]: 74
- Height [mm]: 8
-
Radial Shaft Seal Design: A/
BS - Swirl Type: Alternating Twist
-
Material: ACM
(Polyacrylate) - Dust Cover: with dust lip
-
Nimetus: Volli rongastihend,
Kigukast - Tootja: ELR
-
Kastitüüp: 02T/
02U/ 0A8, DQ250 - Plokieraldus:
- Installatsiooni pool: Esisild
- Inner Diameter [mm]: 50
- Outer Diameter [mm]: 65
- Height [mm]: 8
-
Radial Shaft Seal Design: A/
BS - Swirl Type: Alternating Twist
-
Material: ACM
(Polyacrylate) - Dust Cover: with dust lip
- Tootja: ELRING
Käigukasti liik: Käigukast 5 käiku, Käigukast 6 käiku, Topeltsiduriajam, 6-käiguline
Laki Auto universaaltooted
TecDoc sõidukite kataloog
TecDoc veokite kataloog