Tootekategooriad
Filter Pidurid Šassii Roolimine Jahutus/kliima Elektrisüsteem Lisad Jõuülekanne Väljalaskesüsteem Kere Süüte-/eelsüütesüsteem Mootor Klaasid/klaasipuhastus Kütusesüsteemi seadmed HooldusToode
Kirjeldus
Laoseis
Hind
(km-ga)
- Inner Diameter [mm]: 14
- Outer Diameter [mm]: 20
- Thickness [mm]: 1.5
- Material: Copper
- Shape: A Shape
- DIN/ISO: 7603
-
Alternative Repair Kit: 017.736,
505.550, 505.540 - Tootja: ELRING
- Lisainfo: 115.100 ELR
- Mootorikood: 19 E
- Material: Copper
- Thickness [mm]: 1.5
- Inner Diameter [mm]: 14
- Outer Diameter [mm]: 20
- Shape: A Shape
-
Nimetus: RONGASTIHEND,
OLI RAVOOLUKRUVI - Tootja: REI
-
Lisainfo: 41-
70089- 00
- Õlivannimaterjal: Metall
- Material: Copper
- Inner Diameter [mm]: 14
- Thickness [mm]: 1.5
- Outer Diameter [mm]: 20
- Weight [kg]: 0.007
- Fitting Position: Oil Sump
- Tootja: VAICO
General Information: In the warranty, we always make a distinction between wear parts and vehicle parts. All wear parts are subject to a reduced warranty period and a maximum mileage. Brake components such as brake disks, brake pads, etc. maximum of 1000 km (break-in period). Therefore, warranty claims for brake parts are only reviewed with an installation invoice and a record of the wheel hub run-out measurement, including photos. For brake disks and brake pads, the break-in requirements specified by the vehicle manufacturer must be observed. When replacing brakes, the chassis components must always be checked with regard to clearance and the wheel hub with regard to wobble, and the appropriate documentation must be produced. If the vehicle is no longer in its original condition due to tuning work such as wheel accessories and tracking plates, the entitlement to make warranty claims is lost due to third-party work. The same warranty claims are lost if the vehicle is used for motor sports or similar events.
- Õlivannimaterjal: Metall
- Thickness [mm]: 1.5
- Inner Diameter [mm]: 14
- Outer Diameter [mm]: 20
-
DIN/ISO: 7603 A/
CU - Material: Copper
- Weight [kg]: 0.002
- Observe service information:
- Tootja: SWAG
General Information: These products are designed to be used as originally intended and not modified for purpose. Please ensure the products are installed by a competent individual. N.B. products are usually supplied without fitting instructions.
- Õlivannimaterjal: Metall
- Thickness [mm]: 1.5
- Inner Diameter [mm]: 14
- Outer Diameter [mm]: 20
-
DIN/ISO: 7603 A/
CU - Material: Copper
- Weight [kg]: 0.002
-
Nimetus: RONGASTIHEND,
OLI RAVOOLUKRUVI - Tootja: FEB
General Information: These products are designed to be used as originally intended and not modified for purpose. Please ensure the products are installed by a competent individual. N.B. products are usually supplied without fitting instructions.
- Välisläbimõõt [mm]: 20
- Siseläbimõõt [mm]: 14
- Tootja: AIC
Üldine informatsioon: Our products are usually delivered without installation instructions. Installation may only be carried out by trained specialist technicians. Products supplied by us are exclusively intended for proper and appropriate use. The warranty is void in the event of improper, contrary to the intended purpose or unsuitable application or use. For electronic items that leave fault memory entries, it is essential to submit fault memory logs in the event of a claim. This consequently concerns all electronic items that are detected, monitored and controlled by the engine control unit, such as sensors of all kinds (e.g. NOX sensors, ABS sensors), mass airflow sensors, airbag slip rings, headlamp levelling control units, throttle valves, lambda sensors or EGR modules. If you encounter difficulties during a repair (troubleshooting max. 1 hr.), please contact technical support at: Phone: 040 - 25 30 66 55 Email: service@aic-germany.de This often avoids extensive troubleshooting that is disproportionate to normal repair times. The following applies to complaints: The more complete the processes are submitted, the faster they can be processed. Complete documentation includes the warranty application (incl. KBA no., chassis no., first registration, engine code, mileage), first and second installation invoice, fault memory log, guided troubleshooting and, if applicable, pictures. Incomplete documentation may result in rejection of the claim.
- Inner Diameter [mm]: 14
- Outer Diameter [mm]: 20
- Material: Copper
- Thickness [mm]: 1.5
- Packing Type: Blister Pack
- Tootja: CORTECO
- Inner Diameter [mm]: 14
- Outer Diameter [mm]: 20
- Thickness [mm]: 1.5
- Shape: A Shape
- Material: Copper
- Alternatively:
-
Nimetus: Rongastihend,
oli ravoolukruvi - Tootja: FIS
- OE-numbri jaoks: 1606230
- Tootja: CORTECO
- Nimetus: COU 423920P
- Mootorikood: 19 E
-
Nimetus: TIHENDIKOMPLEKT,
OLIVANN - Tootja: REI
- Mootorikood: 19 E
- Weight [g]: 69.564
-
Nimetus: TIHENDIKOMPLEKT,
OLIVANN - Tootja: AJU
- Inner Diameter [mm]: 14
- Outer Diameter [mm]: 20
- Thickness [mm]: 1.5
- Shape: A Shape
- Material: Copper
Laki Auto universaaltooted
TecDoc sõidukite kataloog
TecDoc veokite kataloog