Tootekategooriad
Filter Pidurid Šassii Roolimine Jahutus/kliima Elektrisüsteem Lisad Jõuülekanne Väljalaskesüsteem Kere Süüte-/eelsüütesüsteem Mootor Klaasid/klaasipuhastus Valgustus Kütusesüsteemi seadmed Kabiinivarustus HooldusToode
Kirjeldus
Laoseis
Hind
(km-ga)
- Number of circuits: 4
- Lambda Sensor: Regulating Probe
- Tootja: KAMOKA
-
Lambda Sensor: Diagnostic Probe,
Thread pre- greased -
Fabrication Number: ESL-
SK- 000 - Tootja: NTY
-
Nimetus: NTY ESL-
SK- 000
Tavatellimus saadetakse E, K ja R kell 14:00. Kaup saabub kuni 3 tööpäevaga. Tavatellimusse lähevad ainult positiivse laojäägiga tooted. Lisaks tavatellimusele on võimalik tellida ka Express kulleriga (24h). Kulleri hinda täpsusta 6 599 702, malva@lakiauto.ee.
Tavatellimus saadetakse E, K ja R kell 14:00. Kaup saabub kuni 3'e tööpäevaga. Tavatellimusse lähevad ainult positiivse laojäägiga tooted. Lisaks tavatellimusele on võimalik tellida ka Express kulleriga (24h). Kulleri hinda täpsusta 6 599 702, malva@lakiauto.ee.
-
Lambda andur: Sond,
Diagnoosisond - Plokieraldus:
-
Installatsiooni pool: katalüsaatori ees,
pärast katalüsaatorit - Lambda Sensor: Heated
- Number of circuits: 4
- Connector/Clamp: Connector may need adjustment
- Nimetus: LAMBDA ANDUR
- Tootja: MAX
-
Lisainfo: MGS-
615
- Piirangutega toode/piirangu info 2: pliisisaldusega kütuse jaoks
- Lambda andur: Sond
- Väljalaskesüsteem: eelkatalüsaatori jaoks
- for OE number: UNIVERSAL fit
- Quality: OE
- Manufacturer Restriction: DENSO
- Thread Size: M18x1.5
- Cable Length [mm]: 750
- Number of pins: 4
- Weight [g]: 103
-
Lambda Sensor: Heated,
Finger probe, Lambda Sensor - Tootja: DENSO
-
Nimetus: DN DOX-
0117 - Kvaliteediklass: Q
Lisainfo: "Tootja: DENSO
A4 AVANT (8D5, B5),
(kvaliteediklass: Q)"
- Lambda Sensor: Regulating Probe
- Voltage [V]: 12
-
Length [mm]: 1,
500 - Number of circuits: 4
- Weight [kg]: 0.18
- Resistor [Ohm]: 6
- Operating Mode: Electric
- Warranty: 3 years warranty
- Tootja: SKV GERMANY
- Lisainfo: 09SKV657 SKV
-
Line insulation design: with silicone-
coated woven- fibre insulation -
Cable Length [mm]: 1,
250 - Number of circuits: 4
- Version: ZR PLANAR
- Weight [kg]: 0.181
-
Lambda Sensor: Thread pre-
greased - Tootja: VEMO GERMANY
General Information: In the warranty, we always make a distinction between wear parts and vehicle parts. All wear parts are subject to a reduced warranty period and a maximum mileage. Brake components such as brake disks, brake pads, etc. maximum of 1000 km (break-in period). Therefore, warranty claims for brake parts are only reviewed with an installation invoice and a record of the wheel hub run-out measurement, including photos. For brake disks and brake pads, the break-in requirements specified by the vehicle manufacturer must be observed. When replacing brakes, the chassis components must always be checked with regard to clearance and the wheel hub with regard to wobble, and the appropriate documentation must be produced. If the vehicle is no longer in its original condition due to tuning work such as wheel accessories and tracking plates, the entitlement to make warranty claims is lost due to third-party work. The same warranty claims are lost if the vehicle is used for motor sports or similar events.
- Lambda andur: Sond
- Väljalaskesüsteem: katalüsaatori ees
- Installatsiooni pool: ees
- Hulk: 1
-
Kütuseliik: Super
(95) pliivaba - Length [mm]: 770
- Number of connectors: 4
- Tootja: VERNET
- Ehitusaasta alates: 10.2001
- Lambda Sensor: Diagnostic Probe
- Voltage [V]: 12
- Length [mm]: 765
- Number of circuits: 4
- Weight [kg]: 0.15
- Resistor [Ohm]: 9
- Operating Mode: Electric
- Warranty: 3 years warranty
- Tootja: SKV GERMANY
- Nimetus: CE 09SKV639
- Lambda andur: Sond
- Installatsiooni pool: katalüsaatori ees
-
Kütuseliik: Super
(95) pliivaba - Hulk: 1
- Plokieraldus:
- Ehitusaasta alates: 07.2001
- Ehitusaasta kuni: 12.2005
- Mootorikood: B235E
- Cable Length [mm]: 300
-
Lambda Sensor: Planar probe,
Heated - Tootja: DELPHI
-
Nimetus: DE ES20315-
12B1
Lisainfo: "Tootja: DELPHI
VECTRA C GTS, 08.02-
(kvaliteediklass: PJ)"
- Installatsiooni pool: katalüsaatori ees
-
Line insulation design: with silicone-
coated woven- fibre insulation -
Lambda Sensor: Planar probe,
Heated, Thread pre- greased - Cable Length [mm]: 210
- Number of circuits: 4
- Weight [kg]: 0.09
- Tootja: VEMO GERMANY
Supplementary Article/Supplementary Info: with squeeze connector, with shrink squeeze connector General Information: In the warranty, we always make a distinction between wear parts and vehicle parts. All wear parts are subject to a reduced warranty period and a maximum mileage. Brake components such as brake disks, brake pads, etc. maximum of 1000 km (break-in period). Therefore, warranty claims for brake parts are only reviewed with an installation invoice and a record of the wheel hub run-out measurement, including photos. For brake disks and brake pads, the break-in requirements specified by the vehicle manufacturer must be observed. When replacing brakes, the chassis components must always be checked with regard to clearance and the wheel hub with regard to wobble, and the appropriate documentation must be produced. If the vehicle is no longer in its original condition due to tuning work such as wheel accessories and tracking plates, the entitlement to make warranty claims is lost due to third-party work. The same warranty claims are lost if the vehicle is used for motor sports or similar events.
- Installatsiooni pool: pärast katalüsaatorit
- Cable Length [mm]: 1
-
Lambda Sensor: Planar probe,
Heated - Nimetus: LAMBDA ANDUR
- Tootja: DLP
-
Lambda andur: Sond,
Diagnoosisond -
Installatsiooni pool: katalüsaatori ees,
pärast katalüsaatorit - Plokieraldus:
- Number of circuits: 4
-
Recommended change interval [km]: 160,
000 - Connector/Clamp: Connector may need adjustment
- Nimetus: LAMBDA ANDUR
- Tootja: BOS
- Lambda andur: Sond
- Installatsiooni pool: katalüsaatori ees
-
Kütuseliik: Super
(95) pliivaba - vajaminev tükihulk: 1
- Lambda Sensor: Heated
- Cable Length [mm]: 750
- Number of pins: 4
- Assy./disassy. by qualified personnel required!:
- Nimetus: Lambda andur
- Tootja: HEL
Brief Information: *** HELLA Electronics OE competence for over 60 years.
- Lambda andur: Sond
- Väljalaskesüsteem: eelkatalüsaatori jaoks
- for OE number: UNIVERSAL fit
- Quality: OE
- Manufacturer Restriction: DENSO
- Thread Size: M18x1.5
- Cable Length [mm]: 750
- Number of pins: 4
- Weight [g]: 93
- Tootja: DENSO
- Nimetus: Lambda sensor
- Kvaliteediklass: Q
Lambda Sensor: Heated, Planar probe, Thread pre-greased, Lambda Sensor
Lisainfo: "Tootja: DENSO
(kvaliteediklass: Q)"
- OE-numbri jaoks: 4570909
- Lambda andur: Sond
- Väljalaskesüsteem: eelkatalüsaatori jaoks
- for OE number: 1367825
- Quality: OE
- Manufacturer Restriction: DENSO
- Thread Size: M18x1.5
- Cable Length [mm]: 770
- Number of pins: 4
- Weight [g]: 131
- Tootja: DENSO
-
Nimetus: DN DOX-
2021
Lambda Sensor: Heated, Planar probe, Thread pre-greased, Lambda Sensor
Lisainfo: "Tootja: DENSO
C70 I COUPE, 03.97-0
(kvaliteediklass: Q)"
- Lambda andur: Diagnoosisond
- for OE number: 4570917
- Quality: OE
- Manufacturer Restriction: DENSO
- Thread Size: M18x1.5
-
Cable Length [mm]: 1,
045 - Number of pins: 4
- Weight [g]: 123
- Tootja: DENSO
-
Nimetus: DN DOX-
2022
Lambda Sensor: Heated, Planar probe, Thread pre-greased, Lambda Sensor
Lisainfo: "Tootja: DENSO
9-5 KOMBI (YS3E), 10
(kvaliteediklass: Q)"
- Lambda andur: Sond
- Installatsiooni pool: katalüsaatori ees
- Number of circuits: 4
- Overall Length [mm]: 700
- Available as universal article as well, see article no.: 0258986615
-
Recommended change interval [km]: 160,
000 - Nimetus: LAMBDA ANDUR
- Tootja: BOS
- Lambda andur: Diagnoosisond
- Installatsiooni pool: pärast katalüsaatorit
-
Line insulation design: with silicone-
coated woven- fibre insulation - Overall Length [mm]: 975
- Number of pins: 4
- Weight [kg]: 0.162
-
Lambda Sensor: Thread pre-
greased - Tootja: VEMO GERMANY
General Information: In the warranty, we always make a distinction between wear parts and vehicle parts. All wear parts are subject to a reduced warranty period and a maximum mileage. Brake components such as brake disks, brake pads, etc. maximum of 1000 km (break-in period). Therefore, warranty claims for brake parts are only reviewed with an installation invoice and a record of the wheel hub run-out measurement, including photos. For brake disks and brake pads, the break-in requirements specified by the vehicle manufacturer must be observed. When replacing brakes, the chassis components must always be checked with regard to clearance and the wheel hub with regard to wobble, and the appropriate documentation must be produced. If the vehicle is no longer in its original condition due to tuning work such as wheel accessories and tracking plates, the entitlement to make warranty claims is lost due to third-party work. The same warranty claims are lost if the vehicle is used for motor sports or similar events.
Laki Auto universaaltooted
TecDoc sõidukite kataloog
TecDoc veokite kataloog